Question about 2006 Cadillac CTS

1 Answer

How does the traction control on cadillac dts 2006 become deactivated

Posted by on

  •  Stephen
    Stephen Aug 19, 2012

    you mean how can you deactivate it yourself ?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,468 Answers

There should be a traction switch on the dash to shut it off when you don't want it it will reset every time you start the car the switch can say etc or trac or slip

Posted on Aug 19, 2012

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

super_guy

  • 1986 Answers

SOURCE: rear door panel 2002 cadillac dts

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

Anonymous

  • 1 Answer

SOURCE: Traction Control Light

theres a low tire

Posted on Mar 20, 2009

James Young

  • 4044 Answers

SOURCE: how to remove head light in 2006 dts cadillac

ok, In this New of a vehicle there are no screws holding the headlight in if you just need to replace a headlight because it is burned out. Look at the back of the light where the wires attach and you should see the wires going into what appears to be a coupling. Get a hold of that and turn. After it unlocks you can remove and replace the bulb. If you are replacing the Headlight assembly because it was damaged there are typically 2 long scews on the top front that appear to be adjsutment screws and 2 smaller ones in each side, again on top. Good Luck

Posted on Aug 27, 2009

Anonymous

  • 9 Answers

SOURCE: 2006 cadillac dts - one of the headlights want

Have you changed the bulb on that side of the car? If a bulb is broken or burnt out it will not light up.

Posted on Dec 18, 2009

gtyner

  • 280 Answers

SOURCE: how do you change the headlight bulbs on a 2006

you should have to go thru under the hood to the backside of the lamp assembly. There should be either a hard plastic cap or a plastic dust cover that has the wires going thru it to the lights. If it is the hard cover (looks like a jar cap) turn it 1/4 turn counterclockwise and pull it out of the way. Take the bulb/socket out. Unclip the old one- Put the new one in. (DO NOT TOUCH THE GALSS PART OF NEW BULB). Then re-assemble

Posted on Mar 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake system wiring for 2006 dts .dose it work the shifter solonoid


shift interlock system solenoid ? Doesn't gear selector move from park ? DTS ???? Cadillac ???? If it is the cadillac dts , brake pedal position sensor is a input to the BCM - body contol module . The BCM controls the shift lock control solenoid . Your best bet , take it to a qualified repair shop.

May 18, 2018 | Cars & Trucks

1 Answer

How can i fix traction control stabilitrak on my 2006 cadillac dts


if trouble light on have vehicle scanned most auto stores offer service for free --the code will direct you towards repairing the problem which can be abs sensor --speed sensor to possible short in harness

Jun 08, 2017 | Cadillac Cars & Trucks

1 Answer

Misfire on 2-4-6-8 cylinders


Welcome to the Cadillac world. These are the second worst to work on when it comes to computers/wiring. Mercedes are the worst. Diagnostic time at my house is $300(tells you what is wrong). I refuse to do them at work, they don't charge enough and I get yelled at for taking to much time. Just take it to a dealer.

Jul 22, 2016 | 2006 Cadillac DTS

2 Answers

Why does my ABS light stays on and sometimes i get a vibration in the brake petal causing my 2002 Cadillac escalade not wanting to stop?


Sounds like a fault with the Antilock Braking System. The vibration in the pedal is the ABS working. With your foot on the brake pedal, it releases and re-applies the brakes to stop a skid from the wheels locking up. You need professional service for brakes.

Seems to be a known issue on all Cadillac and requires the ABS module to be replaced.

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > DeVille Cadillac DeVille ABS Light Due to ABS Control Module Failure. This is a verified problem based on 126 reports. Learn more about this problem, when it occurs ...

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > Seville STS Traction control and ABS lights stay on dash. This is due to ecbtm Module gone bad. replace Module and this should fix the problem. You can go by the VIN and ...

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > DeVille DTS ABS Light Due to Control Module Failure on Cadillac DeVille DTS. The anti-lock ... ABS and Traction control light stays on. ... abs light to abs control stay on.

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > Seville SLS ABS Light Due to Control Module Failure on Cadillac Seville SLS. The anti-lock brake ... SLS135,000Jumsee. Abs and traction lights stay on when started.

Jan 12, 2016 | Cadillac Cars & Trucks

1 Answer

Dts 2008 - traction control warning light on and drive bad.


Could be your front hubs having loose wheel bearings if your traction control is showing a malfunction.

Feb 17, 2015 | 2008 Cadillac Dts

1 Answer

What does it mean when my service stability,abs and traction control light come on in my 04 Cadillac DTS


Could be a broken wire. Speed sensor, wheel bearing, and all that stuff they put on it. Have the codes read. This will point you in the right direction.

Feb 11, 2015 | 2004 Cadillac DeVille DTS

1 Answer

Engine reduced power on 06 Cadillac dts


There are many many causes for this, and troubleshooting depends on under what circumstances this occurs. However, one thought comes to mind - if the vehicle is acting as though the traction control is engaged, make sure to try turning it off.

Oct 06, 2014 | 2006 Cadillac DTS

1 Answer

Stability service light and traction control light came on my for 2009 cadillac dts


Chances are you have a wheel speed sensor that is not reading correctly.

Sep 02, 2014 | 2009 Cadillac DTS V8

1 Answer

What is yellow triangle shape symbol with car skidding mean on cadillac dts


It means that either the traction control has been deactivted or that ther is a problem with the system.

Aug 19, 2012 | 2006 Cadillac CTS

Not finding what you are looking for?
2006 Cadillac CTS Logo

Related Topics:

538 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...