Does anyone know where these sensors are located on a 2000 Buick Regal, v-6? Would love try and replace, but I don't know where they are. I bought a manual for the car, and the only thing I know is they are removed to drain the coolant.
SOURCE: how to replace a coolant level sensor, 2000 buick century
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
SOURCE: how to replace a crank sensor on a 93 buick regal 3.8L engine
Im assuming this is the Series I 3800? If so, if you can email me I can send you some directions on the process. Its for a Series II 3800 but it should be similar. If you cant email me, post up and I'll see what I can do.
SOURCE: buick regal 1996 crankshaft position sensor
IF THE CRANK SENSOR GOES BAD ON THAT ENGINE THE CAR WILL STOP RUNNING OR NOT START IF TRYING TO START IT. NEED THE CODE INFO TO HELP YOU FURTHER. TRY GOING TO ADVANCED TO GET THEM TO READ THE CODE-THEY DO THIS FOR FREE.
SOURCE: Low coolant sensor on a 1998 buick
The coolant sensor should be located near where the upper radiator hose is attached to the engine and has a wire connector on it with 2 wires. It's the only sensor near there. Then there's the sensor that'll be attached to your reservoir tank somewhere along the firewall
Testimonial: "Thanks so much for your help! We went right to it!! "
415 views
Usually answered in minutes!
×