2001 Ford Mustang GT Logo

Related Topics:

A
Anonymous Posted on Aug 14, 2017

01 mustang gt motor skips ae idle and when in drive

U can start my car up cold and run fine but about half way normal temp i have a skip when i sit and idle and when its in drive and sitting still bacicly when it has a load in the motor it skips i replaced at coil pack and plug and cleaned idel control valve . also my check engine light is on for o2 sensior but thats bc i have a mac pro h pipe on it i thank please let me no something! thanks

5 Related Answers

Anonymous

  • 33 Answers
  • Posted on Aug 07, 2008

SOURCE: Triton V10 Engine Shudders under load

have your fuel system vacuumed out our excursion did it as well the injectors are not at fault it is the fuel lines

Ad

Anonymous

  • 57 Answers
  • Posted on Jun 14, 2009

SOURCE: My 2002 Ford Taurus will shutter and die when

the idle air control valve is responsible for engine idle.
this is a common failure on ford's. but I don't think yours is bad because it does idle high befor it dies.
you stated you had codes p0171 and p0174 these are lean codes for bank one and two, you said you found a vacuum leak and repaired it, the vacuum leak was mostly likely the cause of the lean codes, however the pcm has calibrated the fueling stategy for this lean mixture, what you need to do is erase the KAM "keep alive memory" this is done by unhooking the negative battery cable for 60 seconds, this is the only way to erase the KAM the $6000.00 machine I use wont even do it.

once the KAM is clean the computer will go into a relearn state and all operating values will be adjusted for the vehicles current condition, during this relearn session the vehicle may have some driveability issues (low or high idle, stalling, poor fuel economy) the relearn should complete within 10 minutes of idling and then 10 minutes of driving.

good luck and keep me updated

[email protected]

Anonymous

  • 58 Answers
  • Posted on Sep 09, 2009

SOURCE: ford mustang - year 2000 - 3.8 liter. The coil pack is out?

I replaced the coil pack to no avail. I also purchase a code reader while at the auto parts store. This device told me cylinder 3 was misfiring (P0303). I found that the spark plug wire had shorted out on the manifold sensor tubes. Replaced that wire and done.

I highly recommend keeping a code reader in your car tool kit. very useful.

Anonymous

  • 253 Answers
  • Posted on Jun 04, 2010

SOURCE: 2002 Ford Windstar p0300 skips and backfires under load

Just put a coil on a 2002 today. Coils fail a lot with no codes given

Anonymous

  • 7 Answers
  • Posted on Jan 29, 2011

SOURCE: 1999 ford ranger 4x4 4.0L

your codes are your truck is over heating and u have bad o2 sensores canobd2.com

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Transmission is slipping when gets warm I have 07 focus

miles on the box , 250,000 miles up?
didnt scan the OBD2 port for errors, why skip scanning it.
so all gears slip even R and L (PRNDL)
drive shifts all gears but all gears slip if loaded too hard
or upshifts to any gear FLARE , a.k.a false neutrals.
or Drive stuck on 1st gear.
the warmer the fluid that more the seals leak inside and add up to, too high
and then slips. the end of life of A/t boxes end like that (no other failures)
scan it next,
never skip the scan,

fluid does not smell burn
fluid does not look like tar
fluid level good. hot engine, idling, in park
L>>>>>>>x>>>>>H
fluid lever about here.
0helpful
1answer

Mustang gt skips until warmed up

may be the heated oxygen sensors or the mass air flow sensor
0helpful
1answer
1helpful
1answer

Mustang 2003 check engine light on. Had diagnostic run at AutoZone and they gave me the following codes: p0316 and p0301. car skips like it wants to cut off. Can I still drive until I get it looked at with...

If the light is flashing - NO. It means you are dumping raw fuel intot eh catalytic converter (very expensive).

If steady, drive sparingly.

01 is cylinder #1 misfiring. Could be spark plug or coil.

16 is misfire detected during start up.
0helpful
1answer

I have a 93 grand cherokee lerado with the 5.2 engine. the first thing to happen is the ignition coil went all of a sudden while driving. replaced the coil and ran great for two weeks then it started to...

How did you determine bad coil? was it not sparking period? I ask because coils rarely if ever go bad... What is the fuel pressure? Are the injectors firing? Spark plugs fouled?
Other sensors to check: Coolant temp sensor? Manifold air temp or intake air temp sensor? O2...These will change your air/fuel mix at temp if they're bad...
1helpful
1answer

Rough idle then stalls

Vacume leak or bad idle motor. With the car in park and running with the hood open listen for leaks moving your hand around the different hoses looking for a change in the sounds that you hear. The idel motor also makes the car idel up to 1500 RPM or so right at start-up then idel down, If it doesn;t the idel motor is likly. Check engine light is on when running? Test for codes, Follow code test charts don't skip any steps!.
0helpful
1answer

RUNS GOOD STALLS AT DIFFERENT TIMES; ae. STALLS HOT OR COLD

when you removed the water pump, did you disturb the timing in anyway ???

1helpful
1answer

2003 Mustang engine skipping when accelerating

Does it idle fine? Sounds like a vacuum leak.
Not finding what you are looking for?

50 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...