Question about 1990 Jaguar Vanden Plas

Open Question

Vcm code fuel fail 11

Car was hesitating now will not start

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

volker206

  • 2 Answers

SOURCE: 1992 XJ6 fuel fail code 22

FF22 is Fuel Pump Drive failure
ECU looks for sognal to the fuel pump relay.

found in jaguar-forum:
"I'm 99% sure that you have a bad fuel pump connector sending a high resistance fault to the CPU. Check your fuel pump connector at the pump. There is a very short harness in the trunk behind the spare tire and the panel behind it. I think the wires are red and blue? Anyway, the tough part is where they tend to go bad is actually at the pump in the top of the tank. You will not be able to get to it unless you have very small hands. You can get to it easier by dropping the tank a little, you probably won't have to remove the lines, just the tank straps. I have seen this connector overheat and burn. Try and clean it up and apply white grease to it.
If you start to have stalling problems in the future, strongly suspect this. Jumping the fuel relay gave me a little extra juice to the pump so I could move the car."

Posted on Mar 31, 2009

Ad

Anonymous

  • 4 Answers

SOURCE: 1992 Jaguar XJ6..vcm error codes

code 24 is the ignition amplifier circuit

Posted on Sep 08, 2009

elbert0315

  • 1 Answer

SOURCE: Check engine light VCM code "FUEL 14"?

car will not start its getting fire

Posted on Nov 09, 2009

iambanshee74

Kori Policy

  • 3489 Answers

SOURCE: what does the check engine light vcm code

this has to do with the engines ability to warm up and meter the fuel. either the thermostat is sticking or the coolant temp sensor is out of range. there are 2 of them at least, one for the guage and one for the pcm. if you find it is the t-stat sticking, replace with jaguar parts.

Posted on Nov 15, 2009

TDISLine

TDISLine

  • 1874 Answers

SOURCE: 1992 Jaguar XJ6 3.2 litre:

Change all spark plugs. Replace the oxygen O2 sensor, then clear again all faults by disconnecting battery for a few minutes.

Posted on Jul 05, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

89 ford probe hesitates when leaving a red light, then runs fine otherwise, fuel filter?


Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard ...

repairpal.com > Problems > Ford > Probe
Ford Probe Engine Runs Rough, Stalls, Hesitates on Acceleration, Hard Starting, Poor Performance. This is a verified problem based on 9 reports. Learn more ...

Starting Problems - 1997 Ford Probe - RepairPal

repairpal.com > Questions > Ford > Probe > 1997 Ford Probe
Dec 5, 2010 - Starting Problems on 1997 Ford Probe ... If the engine runs rough,stalls, hesitates on acceleration, is hard to start, or has generally poor ...

A new misfire/hesitation on accel. Problem.. - ProbeTalk.com Forums

forums.probetalk.com > Tech Section > 2nd Gen (93-97) V6 2.5L

Feb 05, 2016 | Ford Cars & Trucks

1 Answer

SUV hesitates but will not crank


Car hesitates to start at crank - AnandTech Forums

forums.anandtech.com > Social > The Garage

AnandTech
Oct 2, 2007 - 7 posts - ‎6 authors
wait... does it hesitate to crank or does it hesitate to fire while being cranked? ... If itcranks OK but hesitates to fire, but is fine after it is going and then ... to want to keep the money that you've earned, but not greed to want to ...

Delay before crank start and no starting. : Mercedes-Benz ...

repairpal.com > Problems > Mercedes-Benz > ML350
Car has left me stranded, where key is in the on position but nothing registers ... While turning the key ignition will not crank over at times will take from 5 to 10 .... it off for a short errand and go right back to start is when I notice more hesitation.

Truck will turn over but won't crank (auto, spark plugs, fuel ...

www.city-data.com > City-Data Forum > General Forums > Automotive

Jan 07, 2016 | Cars & Trucks

1 Answer

What is wrong with my 2006 V6 Cadillac hesitates to start after refueling


Hesitates after refueling, have someone check the FPR, Fuel Pump and Filter.
If you have junk in the tank, it will circulate when you add fuel to the system.

Hope this helps

May 04, 2014 | 2006 Cadillac SRX V6

1 Answer

My 91 honda accord drives fine,but after driving for a while it starts to hesitate and only drives when i accelerate and decelerate what's the problem?


If the car starts to hesitate at right around 2000 to 2300 RPMs then the EGR ports on the intake manifold need to be cleaned out. The exhaust gas is flooding only one cylinder and causing the hesitation(misfire of that flooded cylinder) since all the other ports are blocked off with carbon build-up. This happen right when the EGR valve opens, letting in the exhaust gas. To find out if this is indeed your problem, remove and plug up the rubber vacuum hose going into the EGR valve and drive the car. If it stops hesitating, that's the problem.

Dec 22, 2012 | 1991 Honda Accord

2 Answers

92 buick park ave 3.8 sudden bad hesitation loss of power


This is likely a problem with the Mass Airflow sensor, it is a sensor that reads the amount of air going into the engine, when it fails it causes severs hesitation and power loss. Contact a local parts store or your GM dealer for a rebuilt one, the part is about $150.00. It is locate in the air intake hose to the engine.

Feb 21, 2012 | 1992 Buick Park Avenue

1 Answer

I know the fluid needs to be changed. It has just started to hesitate to work when I start a turn, but then works fine for awhile. Will it help to have the fluid changed?


It never hurts to change fluids but, hesitation is a product of fuel and ignition, happening at the correct time and in sufficient quantity. Not sure what "hesitates to work" on your car as you were not specific, but any hesitating is generally a mechanical not a lubrication problem.

Mar 21, 2011 | Oldsmobile Aurora Cars & Trucks

1 Answer

94 Honda Accord LX hesitates when starting


temperature sensor for the auto choke

Nov 25, 2009 | 1994 Honda Accord

1 Answer

2003 tiburon hesitating when starting


when last did you service your car?

Oct 12, 2009 | 2003 Hyundai Tiburon

1 Answer

Car stumbles,hesitates,loses power on Hwy, randomly


Did you check earth connection of electric system?

May 10, 2009 | 1995 Oldsmobile Eighty Eight

1 Answer

2003 Nissan Altima hesitates


take the car to autozone and have them run a code search on it.

Apr 29, 2009 | 2003 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...