Trying to change the tail light. Took out 3 screws, but the assembly is still held in place by what? Do I push; pull and which way?
SOURCE: 2002 hyundai elantra tail light replacement
I have done one on 03 if its the same inside of trunk there are several retainers for the interior liner remove these and pull liner back there are 2 or 3 nuts behind that panel once removed lense will come out it comes out kind of hard but it does come out then you just twist the socket out of lense to get to bulb
SOURCE: Adjustment headlights '02 Hyundai Elantra
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
SOURCE: oil change procedure on a 2005 Hyundai elantra
This one is simple
1. Remove dip stick and filler cap.
2. Remove oil plug from oil pan and drain oil into an appropriate pan.
3. Remove and replace oil filter. (Filter will drain oil, just be aware to try and get it into the pan.
4. Refill oil. Start with 3.5 quarts, put cap and dip stick back on and start car, wait about 10 seconds and then turn off.
5. Check your dipstick for proper oil level.
And thats it you are done.
SOURCE: how to change hyundai getz brake light in light cluster?
On the Getz remove 2 screws on the outside then gently prise the cluster off from the dowels as above.
2,112 views
Usually answered in minutes!
Elantra Touring is a station wagon. Open the lift gate to access the 3 screws that access the light assmbly
×