2009 toyota corolla how to reset warning lights for the abs and brake lights

SOURCE: 2009 corolla warning light (!)

I have the same problem the car was bought in March I could not possibly need new brakes this early and I checked the brake fluid and it is full to the max line. What do you mean check the bulbs how do I go about that?

SOURCE: Toyota Corolla Spacio Warning Light

That is the tire pressure monitoring light. Simply air up your tires and it will turn off. If it comes back on then you may have a slow leak.

SOURCE: where is the oil filter on the 2009 Toyota corolla

I assume that you have a 1.8 engine. The oil filter is in a round metal housing under the engine; you have to remove the housing to access the cartridge type oil filter; the 1.8s do not have a "spin-on" filter.

SOURCE: 2005 toyota prius abs brake not working warning

Hmm, I'm not sure what a main chip is but, there is a few reasons for this problem.

1. ABS Sensors - there could be something wrong with a sensor and/or the wiring to them
2. The wheel bearing speed sensor in a wheel is bad or intermittent which then tells the computer that wheel is traveling at a faster or slower rate of speed then the rest which in then the computer turns the abs light on.

Now when your warning lights go on, the computer sets a DTC code which is the key to helping solve this problem. If you can get the DTC (Data Trouble Code) from the dealership or from someone who can scan your can, I can better assist you in figuring out what's wrong. Hope this helps.

SOURCE: How do I reset the maintenance warning light on

To disable this light without unplugging the battery:

1. Start the car.
2. Place odometer on Trip A
3. Turn car off
4. Place your finger and hold the odometer trip button
5. Turn key to the "on" position while holding the trip button; not "acc"
6. Wait until the computer reset finishes
7. The maint reqd light will turn off