I am a woman alone for first time in twenty years i need to know where my fuel filter is on motor
Removal & Installation
Look for the filter on the side of the fenderwell under the hood, if not on either side look on the firewall mounted with 1 bolt.
Print Fig. Remove the union bolt and two gaskets, then disconnect the inlet hose from the fuel filter Fig. Always use new gaskets i need a picture of my motor in my celica gt 2000 - enlarge_icon.gif fuel filter Fig. A line wrench with an extension may be needed to loosen the inlet line at the filter-Corolla
CAUTION
Observe all applicable safety precautions when working around fuel. Whenever servicing the fuel system, always work in a well ventilated area. Do NOT allow fuel spray or vapors to come in contact with a spark or open flame. Keep a dry chemical fire extinguisher near the work area. Always keep fuel in a container specifically designed for fuel storage; also, always properly seal fuel containers to avoid the possibility of fire or explosion.
There are two types of fittings used on fuel filter connections. The banjo fitting or union bolt type uses a bolt and two washers to prevent leakage between an eyelet and the filter. The flare fitting type uses no washers or bolts. It uses a thread interference pattern to make a tight connection.
Fig. Place a pan under the filter, the remove the lower line
CAUTION
To avoid personal injury, remember that the fuel system is under pressure. Release pressure slowly and contain spillage. Wear eye protection and observe no smoking/no open flame precautions. Have a dry powder fire extinguisher within arm's reach at all times.
To install:
When tightening the fuel line bolts to the fuel filter, you must use a torque wrench. The tightening torque is very important, as under or over tightening may cause fuel leakage. Insure that there is sufficient clearance between the fuel filter, lines and any other parts.
WARNING
The fuel pump builds high pressure within the lines. If new gaskets are NOT used, a high-pressure leak may sprai need a picture of my motor in my celica gt 2000 - 0996b43f802094dd.jpgne or other hot surface.
Negative battery cable. On vehicles equipped with an air bag, wait at least 90 seconds before proceeding
Protective shield for the fuel filter
If necessary, air cleaner hose and cap
If necessary, charcoal canister.
Slowly loosen the lower flare nut fitting until all the pressure is relieved
Banjo fitting and 2 metal gaskets. Discard the gaskets
Fuel line with the flared nut from the filter
Filter from the mounting bracket
To install:
New fuel filter
Banjo fitting with a new metal gasket on each side and install the union bolt. Bolt: 22 ft. lbs. (30 Nm).
Flare nut to the lower connection. Nut: 22 ft. lbs. (30 Nm).
Charcoal canister
Air cleaner hose and cap
Protective shield
Negative battery cable
SOURCE: fuel pump for 2000 toyota celica
Yes, remove the rear seat cusion and then lift up the padding. Take the screws out of the cover and them you can access the top of the fuel tank and remove the pump and fuel level sending unit.
Very easy!
SOURCE: location of fuel filter 2000 prerunner 2.7 engine
In the engine bay, on the firewall, behind the engine if it's a 2.7L I4. It'll be tricky to change due to space constraints.
SOURCE: change fuel filter on 1994 celica
1994 Toyota Celica 1.8L EFI DOHC 4cyl
The Fuel Filter is located
under hood, center, upper firewall, mounted in fuel
line.
Common fuel line routing
View of the common electric fuel pump located under the rear seat
Removal Fuel Pump
To install:
I hope helps whit this (remember rated this help) Good luck.
292 views
Usually answered in minutes!
fuel filter is in the tank along with the pump on 2000 celica
×