Could be the crank sensor is bad but If the check engine light does NOT come on when cranking at the times when it won't start, then your ECU is in need of repair. The engine will only start after the check engine light comes on and the ecu is what controls that. It's likely going bad, causing the delayed start problem typical of early 90's jeeps. Repair or replacement services for your jeep ECU are available on ebay.
SOURCE: my 93 jeep grand cherokee
What all have you checked as initial steps? Have you checked the fuel filter as first and foremost step and also Is the check engine light ON?
SOURCE: cranks but won't start sometimes.
From what i've seen over the years with the Chryslers i've encountered. Your describing to the "T" what appears to be a bad Crank Sensor. I will bet money that if you replace the crank sensor it will solve your problem. BUT...Also know that a bad fuel pump can do exactly what you describe in your statement. Once the pump get hot it gets to acting stupid, but yet again so can the Crank Sensor. Still, my money is on the Crank Sensor.
SOURCE: 1992 jeep Laredo keeps blowing 30 amp eng. cntrl
Regards,
Tony
SOURCE: cherokee won't start it cranks but won't
i dont know if this helps, but i know in some models, the security issue is caused by the key itself. if there is an rfid chip in the key and it is not responding to the computer, the motor will not start. try using your VIN to get a new key made at a dealership.
1,017 views
Usually answered in minutes!
×