When it first happened the dome light didnt work either, but now it works but the windows at all switches dont work and neither does the door locks and unlock switches work at any of the doors. The lights on the switches work on all doors but the drivers door. There are no burned out fuses, could it be a wire somewhere that is not making a good connection?
SOURCE: 2003 ford escape, fuse keeps blowing for door locks, radio and dome light. y
check for a shorted to ground positive wire repair as nesseacry
SOURCE: 1997 ford ranger, guage cluster lights,dome light,
It almost sounds like a fusable link,check them you will find them somehere on the fender or the intake mainfold,when you find them if one is bad it will be very soft in the middle cut it out and reolace it.
SOURCE: 1998 Taurus SE warning chime beeps as you get in the driver door
Hi John,
Had a similar problem with my Saturn. Door chime going all the time, the seat belts going up - down - up for no apparent reason.
Turned out to be the switch in the door jamb had become unseated. As it randomly made and broke contact, the cars computer thought the doors were opening and closing, then acted accordingly.
I remounted it with the help of a hot glue gun (plastic mount).
Hope this info helps with your problem.
Best regards
Mike
SOURCE: Door locks on Ford Expedition stuck
Look under your steering wheel right under the dash. There should be a small white strip with 5 numbers. This is your master code for your vehicle. If you bought the car used and they give you a code, they could have made their own code, but the master will override it. If this don't help, the module for the doors may be going bad.
SOURCE: 96 ford explorer power locks or windows not working
On a 96' Ford Explorer XLT (like mine) the code is in the trunk of the truck behind
the plastic cover where your tire jack and wrench are! There will be
two plastic knobs that you will have to turn to open and lift it off,
real simple. The code will be on the fender wall, bring paper and pen to
write and will need a flash light so you can see the code clearly.
The code is real close the the plasic and kinda hard to see. Hope this
helps! If you dont see the above,then try looking around in
that area for a 5 digit code, in the fender well or around the jack, or
even around the rear washer bottle. Most people have said its around the
jack.
Hope this help (remember comment and rated).
247 views
Usually answered in minutes!
×