The sound is a roaring and thumbing sound
Check wheel bearing...transmission output shaft bearing. noise is louder because when bearing slow down, they get louder from worn down ball bearing inside the cage, space is developing between the ball bearing..caused by lack of lubricate, or just worn out bearings
SOURCE: the front vibrates when turn and going under 20 miles on my 1995 camery 4 cld
check the front tie rods jack car up and see if front tire moves from side to side or feels loose
SOURCE: brakes on back new but
soulds like something is not write. jack it up and check it out.try to spin hub to see if you can find the scorce of the noise.there may be something loose.did you open a line in the back?or is your fluid level low?need to bleed the system.have someone pump the brakes 4 times and hold it all the way down.open the little fitting on the caliper.then tighten it back.do this until you see a clear stream of fluid.repeat on other side until brakes are tight.make sure keep fluid level up.
I’m happy to help further over the phone at https://www.6ya.com/expert/kenneth_3efc1f8510674f04
Sounds like you have a wheel bearing problem. Jack up the front end so wheels are off the ground. put your hand on the spring on the strut then turn the wheel with the other hand. If the bearing is bad you will feel the vibration/rough spot in the spring. Noise will get louder or diminish when you peed up or slow down.
551 views
Usually answered in minutes!
×