Where is the speed sensor located on 2000 chvy full size work van with 5.7
SOURCE: how to change fuel pump in 97 chevy 2500 (cargo
You have to drop the fuel tank. It is inside. Hope the tank is near empty, remove the 2 fuel fill hoses, you have two straps, lower tank, remove 3 wire connectors, and several more lines. Please use an ac delco fuel pump module. It may come updated with a new wiring connector to fix the old ones problem. If it does, you have to rewire the van following the directions.
SOURCE: location Fuel Tank Pressure Sensor on a 2005 chevy express van
lOOK UNDER THE REAR OF THE VEHICLE ABOVE THE SPARE TIRE ON A CROSSMEMBER BETWEEN THE FRAME RAILS.
SOURCE: 2000 Chevy Venture shows gas gauge as always full..
if the remote works but the switches inside the van doesn't then the most likely fix would be the switch, tthough it is strange that both would quit. the place too start would be pop out the switch with a small screwdriver and disconnect the connector. the top left pin and the top middle pin is the unlock circuit in the switch. check continuity with your multimeter while pressing unlock. if no continuity, then get a small piece of wire and jump those pins in the connector,( the top right and center ) you should hear the doors unlock, then you know for a fact that the switch is bad. the unlock is used more than the lock so it is a more common failure. you can also use a continuity test on the rear wiper switch. though it is more common that the motor would stick from not being used. hope this helps if you have any more questions i am glad to help... dustang
SOURCE: need to add 13-4a freon to my 2000 venture chevy van. Where is the pressure hose located?
passengers side under the hood.....by the firewall.....
SOURCE: location of the camshaft sensor on a 2000 chevy astro van
The sensor is in the distributor you can get it out with out pulling the distributor but its tight and has to be perfect .... pull the cap off and then the button youll see a sensor under a metal cup looking thing with a wire harness coming out of it i believe you need torks bits for the whole job if you go to any parts store and buy one then pull the cap this will make more sense.
Good luck and hope this helps.
244 views
Usually answered in minutes!
×