Very difficult to engage reverse gear
SOURCE: cannot engage reverse gear
Hi,
To my understanding this is a common problem with Saab 900s. The cure was to replace the existing linkages with an upgraded one. There was even a recall or service bulletin to this effect.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
SOURCE: very loose gearstick first gear doesn't engage
Could be loose cables and out of adjustment or the syncros in the trans about had it.
SOURCE: Problem going into gear
Your clutch system works the same as brakes do. The necessity to bleed tells you that there is a malfunction permitting air into the system. Check where the pedal rod goes into the firewall under the dash, the line itself, and the slave unit (some are inside the bellhousing...look for fluid dripping from bottom to verify if leaking) Not unlike brake master, they can also internally bypass. If you find no leaks, change master. Bleed system and you should be fine
SOURCE: 2002 Volks Jetta GLS-difficult to shift into reverse gear
no recals but if you are the oreginal owner you have untill 2010or 80,000 miles before the warranty runs out, and if you are past that I bleive you will need a T.C.M transmission control module.
241 views
Usually answered in minutes!
×