REMOVAL - 2.0, 2.4, 2.4L TURBO
The Crankshaft Position Sensor is in the front of the engine
block just under the starter motor (CRANKSHAFT POSITION SENSOR LOCATION). Disconnect the negative battery cable.
Raise vehicle and support.
On 2.4L SRT-4 remove the lower inner cooler hose from the metal tube.
Remove the Structural Collar (Structural Collar and Bending Strut-(Automatic Transaxle Equipped) ), refer to the Engine, Structural Collar Removal and Installation section.
Unlock and disconnect the electrical connector to the crankshaft position sensor.
Remove the crankshaft position sensor bolt.
Remove the sensor. Arrow points to sensor in picture.
my 2005 pt cruiser will start just fine and then next time it will not!! I've been taking off the top to that little black box under the hood that the fuses are in the pushing down on all of the fuses, even replaced the one that was listed for the ignition and still it will not start sometimes?? we can't find the problem is there anyone else that has this problem? and if so what fixed it?
pt cruiser knock sensor location
where is the transmission control solenoid located on a 2002 pt cruiser
2004 crankshaft sensor pt cruiser
my 2004 pt cruiser has a bad oil leak when i turn my car on. do i need a new oil sensor
oil sensor location
where are located the oxygen sensors on 2008 chrysler sebring?
Pt cruiser alarm box location 2007
Pt cruiser alarm box location 2007
Connecting a radiator cooling fan to the wire harness in a 2004 Chrysler PT Cruiser
my 2001 PT Cruiser stopped running going down the road and will not start back. will crank but there is no fire to it. I believe it is the crankshaft sensor. where is the crankshaft sensor located on the engine?
×