Lights keep comeing on dash abs traction control off &engine soon light.

What it looks like: The traction control warning light typically takes the form of the acronym "TC." Sometimes this light is a small illuminated picture of a car losing control What it looks like: The traction control warning light typically takes the form of the acronym "TC." Sometimes this light is a small illuminated picture of a car losing control. How this system works: Traction control uses wheel speed sensors to detect when one or more of the car's wheels lose grip and traction. When the system registers a loss of traction in one or more of the wheels, a computer will limit power to the wheels that are still in solid contact with the road to prevent a skid. Common reasons for this to happen:

• ABS is malfunctioning: Traction control and ABS (anti-lock braking system) often share the same control module and internal self-diagnostics system. As a result, sometimes an issue in the ABS can trigger the traction control light. If this is the case, then both the ABS and Traction Control lights will be on.
• Broken wheel speed sensors: Wheel speed sensors are usually in the wheel bearing assembly, and determine the rate at which each wheel is moving. The sensors relay that information to the traction control module, which determines whether or not power needs to be shifted. Wheel speed sensors can get dirty or damaged and stop working, which prohibits the traction control module from knowing when to enable the system.Traction control module is faulty: The traction control module - which, again, is often shared with the ABS - can malfunction and break altogether, causing the system to stop working. What to expect: A top-rated mobile mechanic will come to your home or office to determine the source and cause of the traction control issue, and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs. How important is this service? It's important to have the traction control issue investigated as soon as possible, as adverse driving conditions can arise at any time. While your car is unlikely to incur further damage from a faulty traction control system, it won't be safe to drive in rain, snow, sleet, or other inclement weather, or even possibly through pools of water on the road. Furthermore, the issue that is causing the traction control light to illuminate could also be impacting the ABS.

Service Traction Control - Stabilitrak and ABS light, Help - Page ...

chevroletforum.com > ... > Tahoe & Suburban

Aug 16, 2012 - Service Traction Control - Service Stabilitrak and ABS light came on. ... Its supposed to still be under warranty, "Major Guard". ... I replaced my rear shocks with OEM re-manufactured Arnott shocks (great company) and in the ...

SilveradoSierra.com • Traction Control, Stabilitrak & ABS Issue

www.silveradosierra.com/.../traction-control-stabilitrak-abs-issue-t18976...

Jan 28, 2014 - Traction Control, Stabilitrak & ABS Issue. Tue Jan 28 ... The wife and I got in to head out and see my brother and as soon as I turned the key the ServiceTraction Control, Service Stabilitrak messages flashed and the ABS light came on. ... check your wheel bearings my was gone and caused the same thing ...

Chevrolet Impala Questions - Hello. I have a 2012 Chevy ...

www.cargurus.com > Questions > Chevrolet > Impala

CarGurusApr 6, 2013 - Occasionally when I hit the brakes I get a Stabilitrak Error Message " ... I believe GM still had 3 year/ 36,000 mile bumper to bumper ... After about 2 months of intermittent noises the ABS light came on, the service stabilitrak warning, servicetraction ... Edit....left hub bearing change after the right one changed.

Replaced front hub - now ABS/Stabilitrak lights on... - Chevy ...

Had the same problem with my 2002 Lincoln LS, it was a bad wheel speed sensor. The right front wheel bearing had some play in it, so I had the hub assembly replaced. The hub assembly comes with a new wheel speed sensor attached. After I replaced the hub assmbly with sensor, the ABS and Traction Control lights went off. No problem since!

THIS IS A WHEEL BEARING ISSUE

brake fluid light goes on when the fluid is low. The traction control light may go on as well if the module detects a fault in the traction control system. The abs light may go on at the same time as the trac light if the wheel speed sensor is not sending a believable signal to the abs/trac module.

If one of the wheel speed sensors is faulty, or a hub is bad, that can cause the problem described.

Good luck on repairing this problem.

Traction control and anti-locks(ABS) lights come on there is sensors that are pluged in behind the rotors check and see if they are disconected or loose sometimes when you change your brake pads they might come loose and not making contact.

It's most likely going to be the wheel speed sensor which is located at the wheel bearing. when they become disconnected or the wire breaks your abs and traction light will come on and something your check engine light.

Each wheel has a sensor on it which tells the abs system that your wheel is rolling and lets the cpu know if there is any difference in speed between them. Most likely you damaged one or more of them when you did the work. Check the wiring going to the sensors, if it's not that, then you either need to bring it to a dealer or live without abs and traction control. (abs and traction control work from the same sensors).

Def the wheel bearings/hub/speed sensor. I just bought a new wheel bearing comes with the hub and speed sensor as one. Runs about 80-100 dollars though but abs/traction light went off and stays off now.

The problem is probably the wheel hub bearings and it is more that likely the front. I had the same problem a few weeks on my 00 grand am gt. Connected the car to the tester it gave me a code for left front wheel bearing. I replace both wheel bearings because i figured what the hell they both have the same amount of miles on them. Taaadaaa no more lights!!! Hope this solves your problem.