Panic/alarm system will not stop going after change of battery

2000 Jeep Grand Cherokee Service Repair Manual INSTANT DOWNLOAD

get your car fix right now

central timer module" - Dodge Dakota Forum

www.dodgedakota.net/boards/gen/21983.html

Jan 2, 2009 - 21 posts - ‎18 authors
I have a Dak 2000 3.9 Ltr V6, Single Cab, Bare Bones. ... Panic Mode .... ooops....i mean the remote entry and alarm system does NOT work ... i have a 2002 dakata where can i buy a ctm looked all over nobody sell them can thay be rebuilt ... I was out the door $550.00, and they washed the truck also.

Truck wont work/Key Fob won't work/wont start/wont do anything ...

www.ramforumz.com > ... > Electrical

Apr 10, 2010 - 10 posts
Truck wont work/Key Fob won't work/wont start/wont do anything! ... Maintenance & Repair > 3RD Generation Dodge Ram - 2002 to 2008 Dodge Ram Trucks > Electrical... Soon as I manually unlock the door, and open it.... the factory panic alarm starts going off. .... Vehicle: 2004 Dakota Club Cab 4X4.

alarm going off when opening the door.. embarrassing and annoying ...

www.cumminsforum.com > ... > 3rd Gen. Non-Powertrain

Jan 12, 2012 - 11 posts - ‎9 authors
how do I stop my trucks alarm from going off when I open the door? it did it ... to thetruck and opened driver door (it was unlocked) and the alarm started going off. ... I do not have a remote unlocking device (or it doesnt work) so I do all .... alarm will go off then I have to use the FOB panic button to shut it off.

Keyless entry/panic button/alarm - Dakota Durango Forum

www.dakota-durango.com > ... > Gen III Dakotas

Follow the alarm speaker (Horn sounding off) wiring. It will most likely go underneath the dash. Remove the box for the aftermarket alarm and all its wiring. (Not car manufacture harness) make sure to take it all out as certain models can leave vehicle unable to start if only partial removed.

check grounds

Have you tried changing the battery in the remote? You should be able to hit the panic button to stop the panic

dont you have the alarm key fob? if so that will reset it. just press unlock. If you dont an dits not a OEM Acura alarm you will need to find who makes it and get a new key fob, or have a shop that does alarms to disconnect it.

Get a new battery. If it even starts to get weak, it turns the alarm system into a nightmare. I've had 2 Gr. Cherokees, had the same issue with both, as did a friend.

You might try Opening the Door and Opening the Hood and Disconnecting the Battery. This should reset the System. If this is the Factory Keyless Entry, There is a Relay and a Fuse for this. Check them and see if they are Bad or Blown.

Have you tried putting your Valet (original keys) into the ignition and turning it to the II position?

the alarm may be in "stolen" mode already. what you can do is that you can switch the key into ON position and open the hood, remove the negative terminal from the battery and reconnect after two minutes. this will give the alarm time to reboot and recognized that you have the key to this vehicle.