1988 Mazda RX-7 Logo

Related Topics:

James Harmon Posted on Jul 20, 2012

1988 mazda rx7 starts won't idle

The vehicle is hard to start but will not idle once it is started

5 Related Answers

roniecon

Ronny Bennett Sr.

  • 6988 Answers
  • Posted on Feb 05, 2010

SOURCE: When I try starting my 1987 Mazda rx7 it clicks

Check the battery,have a load test done on the battery,and check the connections at the battery and the battery post,make sure they are shiny clean,then of course check the alternator,to make sure it is charging enough,13.65 volts to 14.25 volts,any less replace the alternator,If all this checks out good,replace the starter.

Testimonial: "Fixed the problem that no one else could even begin to guess what to do."

Ad
RJones1125

Rick Jones

  • 373 Answers
  • Posted on Feb 24, 2009

SOURCE: Mazda well not start after driving short distance

i had something like that happen to my truck. died on freeway, after sitting for four hours it started up and ran fine, one little rectifier in the wiring harness just got hot and killed power to the computer,

Anonymous

  • 957 Answers
  • Posted on Apr 25, 2009

SOURCE: recommended oil for a 1988 mazda rx7

are you sure you want to start using it. Yes it is a great product but it wont bring an old engine, magically, back to life. If anything it is thin like moble-1. So on an old engine it could start to leak oil from the main seals and/or start to smoke from worn rings. and royal purple is a full synthetic. Don't mix it with conventional oil.

Anonymous

  • 1 Answer
  • Posted on May 14, 2009

SOURCE: RX7 with 13b engine is hard to start, idles fine, dies on accel.

problem like this on garden tractor ,was weak coil ,-when engine at low manifold pressure[idle] spark could jump gap and fire cylinder ,higher pressure /under load-wouldn't fire...check color of spark -orange,yellow ,white spark=weak, blue spark is stronge,

Anonymous

  • 10 Answers
  • Posted on Apr 26, 2010

SOURCE: I have a 1988 mazda rx7 tries to start but for

it could be your wiring for your primary injectors.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers
1helpful
1answer

1988 Mazda RX7 won't start, just clicks

check battery and connection.could be starter try to tap the starter.tune up.
0helpful
1answer

When i accelerate my 1987 rx7 which is fuel injected starts to sputter and at times shuts off what could be the mal function?

Too many things it could be with a burn car. It is very hard to give a proper diagnostic evaluation without being able to put your hands on the vehicle. You probably still have some sensor or component issues. I recommend you download the FSM at http://foxed.ca/
That will give you the diagnostic procedure.
0helpful
1answer

Won't start easily since it got cold (32degrees). It's fine once it starts

Its cold start issues:----

Go through the list of help links mentioned below:----


Click the link :----


Cold start problem and vehicle shudder around 2500 to 3500 rpms

http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

----------

Low idle when cold out side?

http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html

--------------

Ford explorer 4.0 will not idle when cold?

http://technoanswers.blogspot.in/2012/02/ford-explorer-40-will-not-idle-when.html

--------

Automatic transmission shift lever hard to move on cold mornings?

http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html

----------

Car won't start when cold?

http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-when-cold.html

-----------

These will help.

Thanks.

0helpful
2answers

2004 Mazda RX8 won't start

You already were told by a mechanic what your
cars issues were

Most likely you need a need timing belt or some
sort of engine work
0helpful
1answer

1988 Mazda rx7 window won't raise or lower

Its either the switch or the window regulator. They all 'live' on the passenger side by the way. I have had both replaced on passenger side over the years on my '88 convertible and guess what? Passenger side window decided not to go up today..down yes..up no so I hope its just a switch. She goes into the hospital Monday. Good luck with yours.
0helpful
1answer

1988 rx7 hard to start, dies on accel

did you install the filter the correct way
sounds like the pump is not working properly
a faulty regulator will dump excess fuel
1helpful
1answer

I have a 1988 Mazda Rx-7 non-turbo and not all the time but every now and then when i go to start it it cranks but wont start. Is the engine flooding or is it something else?

I always start my '88 RX7 with a 2 start procedure. First start is short about 3 engine revs...second time it always starts.
If I don't do that it cranks & cranks.....try it.
1helpful
1answer

RX7 with 13b engine is hard to start, idles fine, dies on accel.

problem like this on garden tractor ,was weak coil ,-when engine at low manifold pressure[idle] spark could jump gap and fire cylinder ,higher pressure /under load-wouldn't fire...check color of spark -orange,yellow ,white spark=weak, blue spark is stronge,
Not finding what you are looking for?

265 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...