Would like to replace door lock actuator.
SOURCE: How to replace headlights on 2000 Jeep Grand Cherokee
One long bolt at the top - requires a 7mm socket to remove the bolt. The light housing will pry out with a screw driver. There are three ball and socket type connectors that hold the housing in and I just pryed off the plastic housing carefully and "balls" pop out of the sockets. Finally, I was replacing the faded plastic housing and it came with a new wiring harness. It's impossible to reach the connector to use the new wiring harness that comes with the new plastic light housing. So just use the existing wiring harness with the new light assembly.
SOURCE: window motor replace 2001 jeep grand cherokee
You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.
SOURCE: 2002 jeep power windows and door locks stopped
SOUNDS LIKE YOU HAVE BROKEN WIRES BETWEEN DRIVER'S DOOR AND BODY AT A PILLAR..PULL RUBBER BOOT FROM BODY AND DOOR AND INSPECT WIRING HERE
SOURCE: Doors automatically lock
This cannot be done. That is the type security it comes with. Except you wanna remove it totally.
Cheers.
SOURCE: 98 Jeep Grand Cherokee Power Door Lock Problem
I have a 1996 Grand Cherokee - the same problem, except my interior lights flash on and off at the same time. Did you get your problem solved?
721 views
Usually answered in minutes!
×