If the shifter wont move with brake pedal pushed ck , shift interlock,brake pedal switch,and key interlock. if the shifter moves and trans does nothing ck cable underhood at trans for operation if working yes you have trans problem . ck fluid to see level or if burnt fluid will smell real bad if low trans wont work right.and a trans can fail with out setting any engine or trans codes.so ck engine light wont come on. there is some times a release by the shifter a small cover you pull off and stick a key or small screw driver in slot and shifter will move.
SOURCE: 1999 ford taurus automatic wont go into any gear -engine is fine
Just a couple of things to check if you haven't compare the smell and apearance of the tranmission oil to so new, if it looks dark and smell burned you probably have a bad transmision, clutches or burned up. Does it whine or make any noise? a stopped up filter will do this. also is it full when warm on the dip tick runniing in park?
SOURCE: 1999 ford taurus transmission
Your problem is the speed sensor. The VSS (vehicle speed sensor)
is located on the right side of the transaxle, near where the right side axle shaft
connects to. To access this part is pretty tricky, if you are inexperienced. There
is an aluminum foil covered shield around the wiring connector. You will need to
remove the shield to gain access. You may even have a damaged wiring
connector, that is causing the problem due to the close proximity of this part to
the catalytic converter. If you want to purchase this part from the Ford dealer,
ask the parts counter person for the "basic" part number 9E731. Hope this helps.
SOURCE: 1999 ford taurus
check the fuel pump itself.. if no fuel going through lines... injectors won't work.
SOURCE: 1999 ford taurus emission reading p0171 and p0174
just tune up ur car periodicly, clean filter. clean ur sparkplug.
951 views
Usually answered in minutes!
×