SOURCE: How do I replace a knock sensor for a 1992 toyota
First, I would like to mention that most knock sensor codes are not caused by the knock sensors, but a mechanical problem with the engine. The knock sensors cannot differentiate between noises caused by mechanical problems like a bad pulley bearing, bad motor mount, noisy alternator bearings, etc. and spark knock. knock sensor codes are set when the computer has retarded the timing as far as possible to compensate for ignition ping (Spark Knock) and the noise still exists.
With that said, here are the instructions.
Remove the Intake Chamber assembly.
Disconnect Injector connectors.
Disconnect the heater hose from the Intake Manifold.
Remove the 9 bolts. 2 nuts, 2 plate washers and Intake Manifold assembly.
Remove right hand engine mounting stay and water outlet.
Disconnect the following hoses and connectors:
Radiator inlet hose.
Engine coolant reservoir hose.
Engine Coolant Temperature Sensor connector.
Engine Coolant Temperature Switch connector.
Ground strap connector.
Remove the 3 bolts and right hand mounting stay.
Remove the wire band.
Disconnect the water bypass hose from the inlet housing.
Remove the 2 bolts, 2 nuts, 2 plate washers and water outlet.
Remove the 2 gaskets.
Disconnect the Knock Sensor connectors.
Remove the Knock Sensors.
SOURCE: Location of knock sensor on 1994 toyota 22vre engine
The Knock sensor on a 22re is located under the intake manifold on the engine block. to the upper left of the oil filter. With is the passenger side of the engine. I believe it is yellow in color. Not do be confused with the oil pressure sensor which is close by. The knock sensor has a larger electrical connector. Good luck it can be hard to get to.
SOURCE: Need to locate knock sensor on 1999 camry V6. Where is located.
i have toyota windom 4vz-fe i need locate knock sensor
SOURCE: 1998 toyota camry , 2 codes, p0171. + p1133
P0171 lean code. Clean the maf sensor. A f sensor is inthe exhaust pipe.
519 views
Usually answered in minutes!
×