Radio does not work in 1993 crown vic, want to put in a replaceme

No,not without a lot of switching of electronics

1993 is OBD1 & 1996 on is OBD2 System

The engine may be okey-- but not the induction
system or any electrical

look under seat and u will ee the rails on each side of seat rock seat back and forth to locate wich bolt is loose or broken or if the rail itself is broken if rail broken remove the seat and order or go to a junkyard for the rail

you need to check the main fuses.it may have blown up your alternator aswell. or burnt out the earth lead to the car body work.

1998 Crown Vic, is it a former police vehicle?

Yes, it will, as long as it is the same motor........

Their is a main fuse for the instrument pannel.

Check the fuse for your cigar lighter/horn. I've seen the fuse blown from the lighter shorting. It will caue the cruie not to work also. I hope this helps. Good luck.

The quickest way to find a short circuit is by putting a bulb in place of the fuse. Anytime the time the bulb lights there is a load. And if the load is a shorted wire the brightness of the bulb will give you a hint. So while you're at it, finding a 'short' is a quicky...keep your eyes on the bulb. gotcha!

Try checking all the grounds for the radio, over time they can weeken. If that doesn't work, put in a new ground wire with a heavier gauge, that should fix it. It sounds like a ground problem.

Good luck, Daniel

I mount bolt is a RELLY hard to remove. Pay the money and have a mechanic do it on a lift.