It goes up in auto mode but when it hits the top it goes half way down
SOURCE: Driver side window bumps down when closed.
The anti-pinch has to be 'reset', unfortunatly the motor has to be remover and reset. If you replaced the glass yourself... then go back and remove the glass from the regulator, unbolt & remove the regulator from the door (10mm bolts). remove the motor from the regulator. plug power into motor and rotate the drive gear 'UP' 6-10 turns. motor should be reset. reinstall motor, regulator and window. check operation before installing door panel.
SOURCE: door sag
Hello, you need to replace the hinge pins and bushings. Just take a hammer and knock the hinge pins out and put the new pins with bushings in the hole and tap it into place. Some vehicles have a locking ring on the bottom of the hinge pin just knock it off with your hammer and a screwdriver. They don't have to be replaced but, if you want the dealer sells those too. Good luck and any questions please ask.
SOURCE: Have to replace the glass
JUST MAKE SURE BOTH AREAS R CLEN AND YOU SHOULD BE ABLE TO GO TO ADVANCE AUTO PARTS TO GET GLUE OR A WINDOW PLACE
SOURCE: Driver's side window only goes down half way.
locate the relay for the power windows and replace it
SOURCE: left front drivers side power window went down but
Hello and thank you for using FixYa!
Most likely your window regulator cable broke. That is why the glass can not be controlled. You will need to remove it and inspect it to verify.
Thanks Jay!
133 views
Usually answered in minutes!
×