Battery Replacement now resets ??

If on a GM car the battery has been disconnect the windows may need to be reprogrammed
The following steps explain how to program the side door window regulator motors:

1. Press and hold the power window switch until the window is fully DOWN. Continue holding the power window switch for approximately 3 seconds.


2. Press and hold the power window switch until the window is fully UP. Continue holding the power window switch for approximately 3 seconds.


3. The power window regulator motor is now programmed for the express function.


4. Repeat this process for all of the power windows.

This is what I found listed that needs to be checked after battery replacement. Not an autozone job for sure.

ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL

ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : SpecialRepair Requirement

INFOID:0000000006095112

Required Procedure After Battery Disconnection

System Item Reference

Engine Control Idle Air Volume Learning Refer to

EC-18.

Brake Control Steering Angle Sensor Neutral Position Refer to

BRC-8.

Power Window Control Power Window System Initialization Refer to TSB.

Body, Lock & Security Automatic Back Door Initialization Refer to

DLK-9.

Roof Sunroof Memory Reset/Initialization Refer to

RF-5.

Seats Automatic Drive Positioner System Initialization Refer to Owner's Manual.

Audio-Visual System

Audio (Radio Preset) Refer to Owner's Manual.

Navigation System Refer to Owner's Manual.
Rear View Monitor Guiding Line Adjustment Refer to
AV-7.

I suspect that during the battery replacement that the CPU program was corrupted . I suggest that a scanner be used to reset the program and go from there

remove the door panel so that you can get to the power window motor. check that none of the wire connections have came loose from shutting the door. if the problem persist, you may need to change the window motor itself.

Open both doors,lower windows
Shut doors,raise and lower both windows twice
Raise both
Check opperation, should have reset.

I have the same problem. Short term answer for me is to disconnect battery for 30 seconds and then the car will start. I have the infamous dashpod problem and the keys and eveything are coded into the dashpod so I'm hoping when I get mne replaced the immobilser problem will go to,at least the guys who work on my car reckon so.
With the regular need to disconnect he battery I leave the three screws for the battery cover finger tight and the battery contact loose enough to wriggle off. I can do it start to finish in a couple of minutes but is a mjor pain still.

you had something blocking the window path which reset the software control on the window buttons or had the battery power removed. it will reset itself after at least 30 button operations.

connect Heavy Duty jumper cables from battery of a running car to the battery of your TT making sure you get polarities right way round hold the running car in neutral at 2000-3000 RPM for a couple of mins then try starting TT

There is no "reset" for the rear lamp failure system. The light goes out automatically wehen all of the rear lamps (brake and tail) are working. Did you check the brake light in the lower part of the back window? Also note that the lamp sensor is very sensitive; it needs to see all the bulbs to be the same wattage. The wattages can vary from nfgr to mfgr. Let me know waht you find on the 3rd brake lamp in the back window.

all windows run off one fuse. you may have problem with the switch. it self.