Wire harness under driver side front seat got hit and a wire got cut. Repaired it but my clock and radio wont turn on at all

This is something I have experienced and may or may not be your problem. The wiring harness under the seat is cut and exposed from moving the seat back and forth. It is now hitting ground and blew the fuse. You have to find the bare wire and wrap it with electrical tape, then replace the blown fuse. Most of the time, I had to remove the seat to find it. If you change the fuse without wrapping the wire, the first time you move the seat, the fuse will blow.

I had the same problem with my 2005 Impala radio. The soloution was: Locate the wiring harness under the carpet in the passengers side behind the front seat. You need to untape it (there's a lot of tape) take off the plastic covering and look for the Orange wire. Follow the orange wire towards the rear of the car until you see where it splits into 2 Orange wires. Common problem is corrosion at the split. Cut the wires and resplice them together. My problem was solved right there!!

open the harness you damaged and repair the wires, then see how it acts

2009 CHEVROLET SILVERADO C1500 4DR TRUCK WITH 4.3L ENGINE AND STANDARD AUDIO SYSTEM

Remote Start
WIRE COLOR POLARITY LOCATION
Battery RED/WHITE (+) IGNITION SWITCH HARNESS
LOW CURRENT, FOR HIGH CURRENT USE RED/BLACK AT VEHICLE FUSE BOX
Ignition 1 PINK (+) IGNITION SWITCH HARNESS
Accessory 1 BROWN (+) IGNITION SWITCH HARNESS
MAY BE YELLOW ON SOME MODELS
Accessory 2 PINK/BLACK (+) IGNTION SWITCH HARNESS
FOR REMOTE START INTEGRATION
Starter 1 YELLOW/BLACK (+) AT MODULE UNDER HOOD BEHIND DRIVER HEADLIGHT
NOT FOR REMOTE START, FOR REMOTE START INFORMATION
Starter 2 PINK/BLACK (+) IGNITION SWITCH HARNESS
FOR REMOTE START INTEGRATION
Anti-Theft Type GM PASSKEY III® ANTI-THEFT SYSTEM
Anti-Theft Descript THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER
Key Sense PINK (+) IGNITION SWITCH HARNESS
Tachometer WHITE (-) AT IGNITION COIL
Speed Sense YELLOW/BLACK (AC) AT ECM MODULE UNDER HOOD ON DRIVER FENDER
BLACK PLUG PIN #57
Parking Lights LIGHT BLUE (-) AT VEHICLE LIGHT SWITCH
Brake Lights LIGHT BLUE/WHITE (+) AT SWITCH ABOVE BRAKE PEDAL
IGNITION MUST BE ON FOR THIS WIRE TO TEST
Reverse Lights DARK BLUE (+) AT BCM MODULE UNDER DRIVER DASH
Horn TAN (-) IN HARNESS AT STEERING COLUMN
ALSO AT BCM MODULE UNDER DRIVER DASH
Modules
WIRE LOCATION
Please select another category
Doorlocks/Windows
WIRE COLOR POLARITY LOCATION
Power Unlock WHITE (-) AT BCM MODULE UNDER DRIVERS SIDE OF DASH
THIS WIRE UNLOCKS THE REAR DOORS ONLY, WILL REQUIRE A 5-WIRE SET-UP IN EACH FRONT DOOR TO INTEGRATE OR A SERIAL DATA MODULE FROM AN ALARM MANUFACTURER
PowerLock LIGHT BLUE (+) AT BCM MODULE UNDER DRIVERS SIDE OF DASH
THIS WIRE LOCKS THE REAR DOORS ONLY, WILL REQUIRE A 5-WIRE SET-UP IN EACH FRONT DOOR TO INTEGRATE OR A SERIAL DATA MODULE FROM AN ALARM MANUFACTURER

i would use a DLPK module

DLPK (2009 Chevrolet Silverado)
W2W
CC-Heated Seats Activation
DL-Arm Factory Security
DL-Disarm Factory Security
DL-Door Lock Control
DL-Door Unlock
DL-Driver Priority Unlock
PK-Immobilizer Bypass-Data No Key Req'd
RS-RAP Shut Down (Remote ACC Power)
RS-Tach / RPM Output
SS-Entry Monitoring ALL Door Pins
SS-Entry Monitoring Driver Door Pin
SS-Entry Monitoring Front Door Pins
SS-Entry Monitoring Hood Pin
D2D
CC-Heated Seats
DL-Arm Factory Security
DL-Disarm Factory Security
DL-Door Lock Control
DL-Door Unlock
DL-Driver Priority Unlock
PK-Immobilizer Bypass-Data No Key Req'd
RS-RAP Shut Down (Remote ACC Power)
RS-Tach / RPM Output
SS-Entry Monitoring ALL Door Pins
SS-Entry Monitoring Driver Door Pin
SS-Entry Monitoring Front Door Pins
SS-Entry Monitoring Hood Pin


Hope helps.

My gfs envoy does this stuff too. Weirdly i found a wiring harness under the driver seat that has a mind of its own. When these problems happen look under the driver seat and move the wiring harness around. It fixed my problem, it may be a connection that is not making good contact in that harness.

My heated seats, easy exit seat, cruise control, and odometer lights were all effected by this one harness

The last time I checked one of these, the wiring harness for everything you just described is underneath the seat. You'll have to move the seat all the way forward or back to get to the harnesses to reconnect them.

I hope this helps! :) Let me know if you need any further assistance in this matter.

check under the dash on the right side of the vehicle

so after completely tearing the seat apart I found 2 wires going up to the seat belt mechanism from under the seat, these wires got caught in the seat mechanism underneath and were shredded. There must be a small solenoid inside the seat belt mechanism because I could hear it click after I repaired the wires(this circuit is live even with the ignition off) Im not sure how it all works but this solved my problem.

If yor liberty is a 2002 to 2004 it is very likley that the wiring harness is pinched under either the drivers or passengers seat. you need to remove the seats (its only 4 bolts) and lift up the carpet and look at the harness that runs under the seats. I have seen this many times before.By the way i am a Jeep master technicain and have been for 15 years.