1993 Acura Vigor Logo

Related Topics:

Anonymous Posted on Jun 29, 2012

How to install a fuel pump on a 1993 acura vigor ls

Where is this fuel pump located. Is it located in the tank

  • Anonymous Jun 29, 2012

    Where is the fuel pump relay located on a 1993 acura vigor

×

5 Related Answers

Anonymous

  • 373 Answers
  • Posted on Jul 25, 2008

SOURCE: 1993 Acura - intermittent fuel pump operation (no start)

HI...
The common cause of the problem that you related.
Is the FUEL PUMP RELAY " Called MAIN RELAY.
Is located : left side under the dash.
Is a BIG relay gray colour. with a connector of 7 or 8 wires.
I recomend replace the relay.

And letme know if you solve your problem.

I hope this information work on your problem.
Thank you for use fixya.

Ad

Anonymous

  • 1 Answer
  • Posted on Feb 18, 2009

SOURCE: acura RL

Check the fuel pump relay switch which is mounted under dash around the steering column area... thats what mine was doing and it was the fix,,,85 bucks

Anonymous

  • 2 Answers
  • Posted on Mar 21, 2009

SOURCE: 1994 acura vigor has abs and brakes lights on while driving?

Check for brake fluids and make sure all the brake fluid container is closed tightly. Also, you make have to bleed the brakes.

Anonymous

  • 1 Answer
  • Posted on May 19, 2009

SOURCE: location of fuses for 92 acura vigor

they are below the driver side kick panel. It has a round latch turn over clock wise and pull cant miss it. Also there is another fuse box in engine compartment by the battery it has a cover pull it off.

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Apr 23, 2010

SOURCE: can i get to fuel pump on 1999 Acura TL from back

Below are the proper steps to removing your vehicle's fuel tank..



Disconnect the negative battery cable.
Relieve the fuel pressure
Remove the rear seat cushion.
Remove the plastic grommet from the floor pan.
Detach the fuel pump electrical harness.
Disconnect the fuel lines from the fuel pump by compressing the tabs on both sides of each nylon push connect fitting and easing the fuel line off of the fuel pump.
Raise and safely support the vehicle securely on jackstands.
Remove the muffler mount.
Remove the heat shields.
Remove the fuel tank cover.
Remove the drain plug and drain the gasoline into a approved container.
Disconnect the fuel lines and remove the fuel filter and base.
Loosen the fuel tank filler pipe clamp at the fuel tank.
Support the fuel tank using a hydraulic jack and a block of wood or other suitable device.
Remove the two fuel tank support strap bolts and position the straps out of the way.
Partially lower the fuel tank to access the fuel tank filler pipe vent tube and disconnect the vent tube and filler pipe from the tank.
Disconnect the fuel vapor tube from the tank.
Lower the tank from the vehicle.
Installation is the reverse of the removal procedure.



0853314.jpg

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

How do you get to the fuel pump on 1992 Acura vigor

Unfortunately you have to remove the fuel tank,the pump is in it. It isn't that hard to remove on a lift, and if it is close to empty, it might not be too hard on jack stands and a second support on both sides, at the very least.
0helpful
1answer

How can i get to the fuel pump on a 92 acura vigor?

  • REMOVAL & INSTALLATION
  • Print
    The fuel pump on all models except the 1986-90 Integra, is located in the fuel tank. On the 1986-90 Integra the fuel pump is located under the rear of the vehicle, near the drivers side of the fuel tank.


    PRESSURE TESTING

    See Figure 1
    On all models, the fuel pump should run for about 2 seconds when the ignition is first turned ON . By removing the filler cap and listening at the filler, it should be possible to hear the pump run each time the ignition is switched ON . It will then stop again until the starter is activated.


    0900c1528004984f.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Fig. 1: Checking the fuel system pressure

    1. Disconnect the negative battery cable and remove the fuel filler cap.
    2. Relieve the fuel system pressure.
    3. Remove the service bolt and attach a fuel pressure gauge to the top of the fuel filter.
    4. Start the engine and measure the fuel pressure with the engine idling and vacuum hose to the pressure regulator disconnected;



    1986-1989 Integra-35-41 psi. (240-279 kPa) 1990-93 Integra-37-44 psi. (255-304 kPa) 1989-90 Legend-36-41 psi. (250-279 kPa) 1991-93 Legend-38-46 psi. (265-314 kPa) Vigor-43-50 psi. (300-350 kPa)
    1. Check to see that the pressure decreases when the vacuum hose is connected.
    2. If the pressure is higher than specifications, check for a pinched or clogged fuel return hose or faulty pressure regulator.
    3. If the pressure is lower than specifications, check for a clogged filter, defective pressure regulator or leakage in the fuel line.
    4. After inspection, remove the pressure gauge and install the service bolt with a new washer.


    REMOVAL & INSTALLATION

    1986-1989 Integra

    1. Disconnect the negative battery cable.
    2. Relieve the fuel system pressure.
    3. Raise and safely support the vehicle and remove the left rear wheel.
    4. Remove the fuel pump cover bolts and the cover.
    5. Remove the fuel pump mount bolts and the fuel pump with it's mount.
    6. Disconnect the fuel hoses and the electrical connectors.
    7. Installation is the reverse of removal. Use new sealing washers when connecting the fuel hoses. After the pump is installed, turn the ignition switch ON and OFF a number of times to pressurize the system and check for leaks.

    1990-93 Integra and Vigor
    See Figures 2 and 3
    1. On Integra, remove the rear seat and access panel and disconnect the wiring.
    2. Remove the fuel tank.
    3. Remove the pump flange mounting nuts and lift the pump out.
    4. Installation is the reverse of removal. Use new sealing washers when connecting the fuel hoses. After the pump is installed, turn the ignition switch ON and OFF a number of times to pressurize the system and check for leaks.



    0900c15280049850.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Fig. 2: Removing the fuel pump access cover-Legend and Vigor


    0900c15280049851.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Fig. 3: Removing the fuel pump assembly-Legend and Vigor
    Legend

    1. Disconnect the negative battery cable.
    2. Relieve the fuel system pressure.
    3. Remove the maintenance access cover in the luggage area.
    4. Disconnect the fuel lines and the electrical connectors.
    5. Remove the fuel pump from the fuel tank.
    6. Installation is the reverse of removal. Use new sealing washers when connecting the fuel hoses. After the pump is installed, turn the ignition switch ON and OFF a number of times to pressurize the system and check for leaks.
    0helpful
    1answer

    1993 acura LS won't start when i turn the key

    It may be because the engine is not getting all the fuel it needs when the tank is low due to a faulty fuel pump or fuel injectors. More diagnostic tools for car @http://www.obd2express.co.uk
    0helpful
    1answer

    Dont know how to get to the fuel pump

    you have to drop the fuel tank down, only way

    1. Remove the fuel tank.
    2. Disconnect the connector from the fuel pump.
    3. Remove the fuel pump mounting nuts.
    4. Remove the fuel pump from the fuel tank.
    5. Reverse order to reinstall
    6. jayscott155_13.gif
      this is manual directions, not much but hope this helps
      Jay
    1helpful
    1answer

    How to replace the fuel pump on acura vigor 1992

    YOU HAVE RELIEF FUEL PRESSURE BY REMOVING GAS CAP THEN LOOSEN SERVICE BOLT ON TOP OF FUEL FILTER ABOUT A TURN.WHEN FUEL PRESSURE RELEAVED.THE FUEL TANK HAS TO REMOVED IN ORDER TO REPLACE FUEL PUMP.
    0helpful
    1answer

    93 vigor reving in park and dying at stops

    check your fuel tank..you might have bad fuel since it was sitting for awhile
    0helpful
    1answer
    1helpful
    1answer

    Location for fuel pump on a 92 acura vigor

    the fuel pump is inside the gas tank.
    0helpful
    1answer

    1992 acura intacra it dies when you get to a half a tank

    YOUR PROBLEM IS EITHER A CLOGGED FUEL FILTER,BAD PUMP,OR FUEL PRESSURE REGULATOR,OR ALL THE ABOVE.TRY A FUEL FILTER FIRST AND A LITTLE FUEL SYSTEM CLEANER
    36helpful
    4answers

    93 lexus LS 400 how do I replace the fuel pump?

    You will have to remove your back seat to gain access to fuel pump. Fuel tank is located in trunk. No need to take fuel tank down.
    Not finding what you are looking for?

    668 views

    Ask a Question

    Usually answered in minutes!

    Top Acura Experts

    ZJ Limited
    ZJ Limited

    Level 3 Expert

    17989 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6988 Answers

    Thomas Perkins
    Thomas Perkins

    Level 3 Expert

    15088 Answers

    Are you an Acura Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...