Door sagging Whe I oper the passenger door it sags a little.

Sagging door? Place a 2x4 between the door and the door post at the lower hinge and close the door a bit on it,this will raise the door.Try a little at a time until the door closes good.

Need to repair or replace the hinge, bushings are worn. Same prob with my 02 Cavi. Good job GM.

Have you checked the hinges to see if one is worn out ?

replace the door hinge pins and bushings.you can get them from your local auto parts store in the help section or ask the counter person,anyway i did this to fix the sagging doors on my gmc truck.hope this helps....keep me posted

If you have to lift up on the door and or close it hard--likely a bad hinge --each door has two and you can look into replacing the whole hinge or there are kits with the pin and bushings that can be used to repair a hinge.

Driver door would be most common if car that age and you may just need one of the two hinges replaced/repaired.

If your door sags it means the bushings in the door hinge are worn out, but there is a way to adjust it without replacing the hinges if they aren't too bad. If you open your door there are bolts that attach the door hinges to the A-Pillar, most of the time they are accessable from the outside. First get a car jack and position it under middle edge of the open door, put a small piece of wood on the jacking point to protect the door. Loosen the bolts to the hinges and raise the jack so it raises the door up. tighten the bolts on the hinges back up and open and close the door to determine if the door was raised enough to eliminate the sagging.

Likely nothing to adjust.
With the door open, see if the door can be lifted up and down while looking at the hinges. If there is play, the door hinge pins/bushings are worn out, and on some vehicles, the hinges are not serviceable, and replacement will be needed. G/L

3m makes a great spray adhe they sell it at walmart for $10 in the auto section , most of the time do it right in the car remove any side trim and spray between liner and board and smooth down.

put a car floor jack under the door and jack it up loosen the screws and try to close the door, you might need shims or washers. tighten each screw top bottom each one til its down so door must be leviled on the jack then bolt it on one at a time

you could try some door shims in the hinges