I FOUND A SPRING IN MY WINDOW AT THE BOTTOM 2006 COBALT

SOURCE: 2005 chev cobalt

I am sorry, but the factory default radio in all 2005 cobalt models does not have auxiliary audio input jacks anywhere. I wish they did.

Thanks for using the fixya forums!

SOURCE: 2006 Chev Cobalt oil filter replacement

i have a 2006 chevy cobalt LT..and i just replaced my oil filter today!!! after several hours of looking i finally looked on the front side of the transmission block.to the left just below the air intake system is a hard heat resistant plastic black bolt topper.it is 1 1/4" in size..i bought a 1 1/2" size and a 36mm size socket torque wrench..both didnt work..1 1/2 was way too big, the 36mm was just slightly too big..took them back, replaced for the 1 1/4" inch socket and voila!!! is was rather difficult..you will need an extender and some good torquing to do to pop it..but once you do it will pop fine..oh, and you will need a 1/2" drive socket wrench.but the 1 1/4"inch socket..pop it onto a 1/2" drive socket wrench with the extender and you are good to go!!

SOURCE: how to remove inner window crank on 2006 chev cobalt 2 dr

the handle part of the crank is held on by a small ring, you will need a small flat head screw driver- i used a butter knife, as it works better- push the door panel back just enough you can see behind the round part of the handle, you should be able to see the foot of the clip, push it off, make sure you don't do this in the grass, the ring will roll when it falls off. **please note this is a flat ring and only about the diameter of your little finger**

SOURCE: window is off track

1. remove door panel, door latch handle and window crank unless it is electric, then remove electric control panel , usually on top of arm rest.
2, Remove insulation sound barrier (plastic sheet)
3. Inspect window for damage. If none is found, notice where the window normally slides up and down in what is called tracks. There is felt material inside the tracks.
4. Also look to see if the window has dropped out of the two crossed arms that have white plastic rollers on them. Be careful handling these arms because they are very sharp.
5. Look for small tabs holding track to door. Usually top and bottom. Loosen these screws slightly until you can move them back widening the distance between both tracks so that you will be able to slide the window back into the tracks.
6.Once the window is back in track, move the loosened track back up so its just touching the window, then retighten the screws.
7. Test window operation.
8. If the window comes off tracks again, window regular is causing problem and should be replaced.


Hope this helps.


If you would like to correspond further with me on this or any other issue, please feel free to do so.
Bill
ASE Master Technician

SOURCE: i have a 97 camaro rs it has power windows and

it is much easier to replace the motors then to deal with having them off the tracks and chancing breaking the windows when you go over a bump you can usually find the window motors on ebay for under $20