Need to put a switch on my brake pedal then reset my computer
SOURCE: VW Passat 2006 service now
2 options depending on your displays .
Press and hold the service wrench button with the ignition off. While still holding the button, turn your ignition to "on" (but don't start the car). Press the Min clock button and then release the wrench button.
With key off press and hold the 0.0 button on the cluster. With your other hand turn the key to the on position , while still holding 0.0 button, press the minute button for 1 second and you will see the service reset.
cheers
SOURCE: 2007 Passat wagon. I need to reset the air bag warning light.
the air bag light will only show if the ignition was turned on while it was disconnected.
it will defo need to be pluged into the computer to be put out but some smaller garages will have the software to do this and will be a little cheaper.here in ireland VW wanted 50euro to do mine but a small garage done it for 30euro.
you can buy code finders/reset gadgets on ebay but might not be worth it for one job compared to $130.
my suggestion would be to get the main dealer to do it if a normal automotive shop cannot access it.
SOURCE: Resetting the service now light on VW
hold down wrench button on right of steering wheel,turn on ignition, then push the min button on the left.then igniton off and it should be reset
bealz104
SOURCE: VW Passat STOP brake fault warning
Check the fluid level in the resevoir. If it is low then top it up. However, it went low for a reason - maybe it's just because your brake pads starting to wear out or you could possibly have a brake fluid leak.
If your in any doubt have a pro check it out.
SOURCE: How do you reset the service computer display on passat
volks wagon passat engine computer reboot where to plug the device into
117 views
Usually answered in minutes!
×