No power at power window switch

SOURCE: 1994 jeep grand cherokee power window problem

try replacing the master switch it maybe malfunctioning due to wear.or may have shorted out by getting wet or something.since it is the primary control for all windows and power door locks.

SOURCE: windows dont work with their own switch but will with the master switch

My wife drives the exact same car and there is something wrong with the push button that locks the other windows.  Even when it isn't pushed in for some reason it thinks that it is.  I know that is what the problem is, I just haven't fixed it yet!  I think that you just need to take the door apart and clean the plug.  That's what I'm going to try.  Let me know if that doesn't work.  Thanks for an honest rating and for using FixYa!

SOURCE: power windows only operate from the driver master

Check the ground circuits. Find out what wires are the ground suppllies. take a 12 volt test light from battery positive and probe the circuit if it lights up the ground is good is it does not bad ground. I would first check the wires in the door jam. where the harness from the car goes into the door. pull back the rubber cover I have seen tons of wire get damaged in there from the door opening and closing all the time. hope this helps.

SOURCE: 95 jeep grand, all 4 power windows don't work

they all actually switch by swapping grounds and the master switch is where it takes place

Testimonial: "Thanks a lot for pointing me in the right direction. I don't know why I missed the ground on the schematic. I now have 4 operational windows! Woo Hoo!"

SOURCE: Windows on passenger side won't roll down and

you have two wires broken inside rubber boot between drivers door and body of jeep

Testimonial: "Thanks alot very helpful"