2002 Bentley Arnage Logo

Related Topics:

A
Anonymous Posted on Jun 17, 2012

2000 Bentley low oil pressure at idle - 2002 Bentley Arnage

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

What are the output specifications for the oil pressure transmitter (it's a 2-wire sensor)in a 2001 Bentley Arnage? (I need the mA outputs corresponding to various oil pressures, at say, 10psi, 20psi,

the oil pressure hot on your test gauge will be below recommended pressure necessary for the proper lubrication of the engine . The control module as you say will be set higher to notify you before that pressure is reached so that there is sufficient time to shut down the engine
1helpful
1answer

00 lincon navigator 5.4 oil pressure drop's low and light comes on , engine idles rough when pressure drops ,then pressure return s to normal range ,light goes out ,engine runs perfect. Is it my oil

Sounds more like an engine idle issue than a oil pressure issue. If the engine idle drops too low, the oil pump cannot provide sufficient oil pressure. If there is no oil light when the engine is idling normally, then there is no problem there.
0helpful
1answer

Low oil pressure in a 2000 tracker

Check level 1st it might just be bad oil pres. Switch use correct oil u may need to have oil pressure checked with gauge if bad need oil pump
2helpful
2answers

2.8l v6 in a s10 blazer. no head gasket problems thus far. wondering why my oil pressure gauge fluxuates? minor rpm change while oil pres guage does its thing why?

Oil pressure always changes with rpm.
At idle you should have around 10 psi, and it should max out at high rpm around 50 psi or so.
You not only can't have as much pressure at idle, but you don't need it either.
2helpful
1answer

Oil light with a line underneathe it, what does the light indicate?

Low oil, bad sensor, really low idle.
First check oil level.
then if oil level is ok, and oil light is still there, pay attention to idle has to be 750 to 850 RPM.

If idle ok, give gas to increase idle to more than 2000 rpm if light goes away you need a sensor called OIL PRESSURE SWITCH.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92

0helpful
1answer
0helpful
1answer

Oil light came on when idling; oil changed; still happening occasionally. If I put it in park or neutral and rev it - the oil light goes out. Could it be the oil sending/pressure unit? Is there an easy way...

make sure are using a genuine dodge oil filter and correct grade of oil to check further you need to have the oil pressure checked using a master gauge a garage would do this for you if ok replace pressure switch if very low could be pump and bearing wear is the idle speed set too low i would check this
0helpful
1answer

The oil pressure light if turnning on and off at low idle.

Please ignore this light. Or you can take your car for a scan so it could be fitted well to give accurate indications.

Rate This
1helpful
1answer

Oil pressure

At idle the oil pressure should be at least 20# at highway speed it should be at least 30# these pressures are on the low end higher is better.
Not finding what you are looking for?

139 views

Ask a Question

Usually answered in minutes!

Top Bentley Experts

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

old marine
old marine

Level 3 Expert

2426 Answers

Are you a Bentley Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...