Car was hit causing both air bags to blow.car started and ran damage was minimal so i installed new dash with dash harness and driver bag. i used the original ignition switch and key.key is s1 security code.everything works,but when key is turned to start the system to start becomes open and will not activate the starter .da
Don't worry I'm sure you will get the solution of your problem, just check the link I
attached
2000 Ford Lincoln LS Workshop Service Repair Manual
SOURCE: 92 lincoln towncar air bag light flashing
Air suspension is controlled by the compressor in your engine compartment. The compressor runs when the suspension is not level. Either because you have loaded the car with exceptional weight and the system is now adjusting the ride, or you have a leak in the system, or you have a bad sensor.
If you have a leak, the most likely culprit are the air suspension bags, the air suspension solenoids or possibly the lines to them.
Try these sites:
http://www.strutmasters.com/catalog.php?cat=2
http://www.suncoreindustries.com/english-lincoln-town-car-89-06-air-suspension.html
I don't work for either of them. I own a 96 TC and have replaced my air suspension with coil springs form Strutmasters. Work GREAT and I have no more air suspension problems. Rides just as good too. You can't tell the difference.
SOURCE: Air bag light is on... The str wheel controls r never correct
You have a bad clock spring. This is located behind the steering wheel and all electrical functions from steering wheel must go thru it. Pretty common problem on this model. The steering wheel and the steering column trim would have to be removed to replace it.
SOURCE: air bag light comes on and stays on. Never any accidents.
The error code that the "air bag" light flashed was 36--thats read by watching the air bag light and counting the flash code. Thats 3 flashs, then a pause, then 6 flashs there is another pause then 3 flashs, than a pause, then 6 flashs. This code comes with the ignition key in the on position, with engine off (KOEO) 36 is the code for drivers side seat. I had a broken wire on the yellow connector under the bottom of the seat, (towards the rear of the seat). I Repaired the broken wire (easier said than done)and the light went out. code 37 is for the passenger side. If you have back seat passengers, tell them to stop kicking around under the seat. I believe in my case it was caused from the constant back and forth from the automatic seat positioning feature. Good Luck!
SOURCE: I have a 2001 Lincoln Towncar. The air bag light comes on
1st when the airbag light is on the system is disabled, so if u have an accident they will not work, as to the common cause read below.
When the airbag light is on it means a fault has occurred in the system and the airbag diagnostic monitor has disabled the system, the most common problem that turns the light on is a break in the connection to the steering wheel mounted airbag, this is due to a rotating ribbon contact that breaks under the steering wheel that connects the airbag to the wiring harness and the diagnostic monitor, the part is called th clock spring contact, a coiled up ribbon electrical contact that turns with the wheel
SOURCE: AIR BAG LIGHT IS ON DASH LINCOLN LS 2001
When the airbag light (SRS) is on or blinks it means a fault has occurred in the system and the airbag diagnostic monitor has disabled the system, the most common problem that turns the light on is a break in the connection to the steering wheel mounted airbag, this is due to a rotating ribbon contact that breaks under the steering wheel that connects the airbag to the wiring harness and the diagnostic monitor, the part is called the clock spring contact, a coiled up ribbon electrical contact that turns with the steering wheel while maintaining a mechanical connection to the airgag mounted on the steering wheel, to replace this part you must disarm the airbag system and remove the steering wheel, this requires a special steering wheel puller tool and that you disarm the airbag system before you start the work, to do this disconnect the battery negative cable for 1 hour prior.
154 views
Usually answered in minutes!
×