SOURCE: The ignition to my Hyundai Tucson is in locked...
check your key see if its not damaged ok also press the break move the steering wheel slowly and move the key as you are moveing the steering wheel
SOURCE: Rear wheel bearings on Hyundai Accent
no i do not believe they are press in there are held in by a seal try www.autozone.com to see if they have your car listed if they do you will be able to get a diagram showing you how they come a part.
SOURCE: how to remove brake drum rear wheel 2004 Hyundai Elantra
Jack up rear of car till tire is off the ground.
Remove lug nuts & remove wheel.
Remove phillips screw(s) from drum.
Using a hammer, strike the drum to loosen it from the hub.
Remove drum by simutaneously turning it and pulling it outward away from the vehicle.
SOURCE: how many bolts on the thermostat housing?
should just be two bolts, one on each end of the housing
SOURCE: How do i remove the front bumper on a 2005 Hyundai
Please leave 4 thumbs up for this answer.
Under the fron wheel arches remove the retaining screws that attach the splash shields to the bumper, Also remove the 2 screws under there that secure the bumper to the corner of the car panel. Remove the grill and supporting clips that attach the bar to the reo {reonforcement} underneath, remove the screws securing the stone shield panels to the bottom of the bar. If you have flood or spot lights, ensure their mountings are free from attaching between the plastic cover and the reo. The cover should pry away with very little force if any. Hope this helps you, safe driving.
Testimonial: "very helpful, Thanks"
2,220 views
Usually answered in minutes!
I have removed wheel ,brake caliper ,hub nut ,and 4 hub bolts behind hub assembly. Tried a gear puller on hub assembly it just pushed CV axle back. Is there a trick to removing the hub?
×