Cars & Trucks Logo

Related Topics:

Posted on Dec 01, 2008

Wiring problem with cd player and lights on car

  • Brenda Herring Dec 15, 2008

    Having problem getting the Kenwood KDC-MP205 CD Receiver deck to work after removing stock cassette stereo from My 1995 Toyota Corolla.  I could also use the wiring harnass specs from the stock stereo.

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

  • Contributor 2 Answers
  • Posted on Dec 30, 2008
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Joined: Dec 30, 2008
Answers
2
Questions
0
Helped
592
Points
3

If the unit is turning off when you turn the headlights on, check that you haven't used the illumination wire as ground.

The illumination wire will normally measure as 0V compared to chassis ground. When you turn the headlights on it will go to 12V compared to ground. With the headligts off, if you measure your constant power and switched power (aka 'Accessories') lines against the illumination wire you'll measure 12V and everything will seem alright. However, if you turn the headlights on and then measure again (now that the illumination wire has gone from 0V to 12V) you'll measure 0V, since the voltage difference between the 12V constant/switched power and the 12V illumination wire is zero - they are both now at the same voltage and no current will flow.

Once you find (or install) the correct ground wire and you should be right.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Radio will not go off

Hi Steve, I'm glad to help! I'm assuming you installed the CD Player and now it stays on. Most CD Players have 2 power wires, sometimes only 1. If your only has one then you have your power wire connected to a wire on the vehicle that stays hot with the key in the off position. Here's what you do to find the wire you need. Take a test light and place it on a fuse in the fuse block, then turn the key off and if the test light turns off thats where you want to connect the power wire for the CD Player. Then when you turn the key off the CD Player will go off also. Hope this helps and have an awesome day Steve.
0helpful
1answer

Vw polo 6n cd player has power but does not light up or play music

what color is the wire..it may be a memory lead..yellow or orange..some even have a power wire to the antenna so it will raise when the power is turned on..also may check the switches inside the unit that work with the eject part of the system..
0helpful
1answer
0helpful
1answer

I installed a cd player in my car about 2 months ago. It wasnt the greatest installation, as I had an extra wire not going to anything, and the cd player would occasionally short out, and i would have to...

Sounds like you wired the cd player to the tail light fuse and the power wire touched ground. Go to the fuse panel inside the car and check the fuses. The tail lamp one and possibly also the dash light fuses will be blown, replace them after disconnecting the cd player power wires and taping off where they were connected. If you have the factory harness for the original radio still in the dash you can get a wiring harness to directly plug into it from walmart. If you don't have the original harness , the easiest way to power the cd is to tap the cigarette lighter wire.
1helpful
1answer

Need wiring schematic for radio

Are you looking for the wiring diagram for the car or the cd player itself? If you have the wiring diagram for the CD player, and a test light, you can easily install with out the car wiring diagram. If you require more assistance please let me know.
0helpful
1answer

Electrical issues

the lights are probably wired through the radio my blazer is like that you will need a wiring diagram of the radio and the lights to figure it out
0helpful
1answer

Cd player installation

read my other solution on the other one you posted. yes, the fuse is more-than-likely blown. but also you wired it completely wrong. look on my other solution on the other one you posted, it has the correct wiring diagram. there are 2 wires on the wiring diagram i posted that have the lights. one red is the int.light, and the other one is the turn signal wiring.
0helpful
2answers

1995 grand prix

do you have a test light?your speaker wires should be four sets of matching color,dark/light blue,dark/light green,dark/light purple and one other matching set of colors. then there should be one black wire which should be ground.with a test light you can find your power and accesory wires. your power wire will always have power with key on or off,the acc wire will only have power when key on. i hope this will help.
0helpful
1answer

Problems with 91 Corsica Dashlight. Need Help!

Sounds like a wiring over load try rerouting the wires for cd player by running the hot wire to the battery and relocate the ground wire make sure the ire has enough amps and theres a inline fuse.
0helpful
1answer

Car stereo

its pretty simple, the remote wire is used to tell the amplifier that the cd player has came on. once the cd player has came on, the amp then comes on. simply take a light tester that has a sharp tip, turn the ignition until the cd player comes on, and start testing all of the wires. when you hit a wire in which the light tester says there is power flowing through it, turn the cd player off. if the light goes off with the cd player, you have found a wire that is suitable for a remote wire. dont know how to use a light tester? http://www.bcae1.com/testlite.htm
Not finding what you are looking for?

499 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...