Replaced clutch slave cylinder 2 weeks ago, have had no problems till yesterday when brake pedal went clear to the floor . there are no visible leaks.
SOURCE: 94 S-10 Chev Brake problem
This is an easy fix un plug the abs sensor from spindle abs light will come on but the brakes will work only abs will not
SOURCE: Brake Pedal goes to the floor in my 1990 Chevy C1500 Scottsdale
do you have a self bleeder kit? first off, you have to bleed the master cyl back into its self and the combination valve before you go to the wheels. when you do that, I think you will find that you have air in the lines. disconnect both brake lines from the master cyl and put the bleeder kit fittings on the master cyl, then put the rubber tubing with the kit on the fittings and submerge it in the brake reservoir. make sure its full. then pump the pedal until you get a hard pedal. if that is the case, reconnect the lines to the master, then have an assistant pump up the brake pedal with the engine off, and bleed the combination valve which should be connected to the master by steel tubing. pump it up, then hold it down, and crack the fittings loose, one at a time until the pedal goes about half way down, but do not release the brake pedal until the line is tight again, otherwise you will **** air in the lines. after you do all that, go to the farthest caliper or wheel cylynder from the master and bleed that with the same technique,and dont release the pedal until you close the bleeder screw. unless you have a major prob, this will work.
SOURCE: brake pedal dropping to floor
do u have the antilock brake bleeding tool? if not you will need to have the dealer bleed the brakes, the ABS control valve must be electricaly held open to bleed the brakes there of course is a special tool for this.
Testimonial: "Thank You"
SOURCE: why wont my clutch disengage? its hard to shift gears
It sounds like you got air in the lines after changing the stuff. you will need to bleed it like you do the brakes. it may take two people to to do tis. one to pump the clutch while the other works the fitting to let the air out. I hope this helps, and please be kind with a thumbs up. I need to good marks. Raz
SOURCE: 1987 nissan pickup- clutch worked fine one day,
sounds like your clutch master cylinder or slave is no good. do your self a favor and replace them both if you are going to be replacing them.
Testimonial: "Thanks, I'll give that a try. Mike"
135 views
Usually answered in minutes!
×