I have a 2000 nissan frontier 4cyl xe. The a/c only works on full blast (4) and does nothing on the rest of the settings (1, 2, 3)…also when the a/c is blowing on full blast it is only blowing air that is the same temperature as outside. If you could help that would be great but can you please give me detailed directions since I am a novice when it comes to car repairs but I want to do this by myself.
SOURCE: where is the location of the thermostat on a 2001 Nissan Frontier
on the nissian frontiers the thermostat is most likily in the lower radiator hose if you look from under the vehicle you will likily see a round housing with three bolts or nuts just follow the hose up from the rad
Please don't forget to rate!
SOURCE: Nissan 2007 Frontier tire pressure monitoring system
check all the tire pressures first.... then drive it for the next 10-15 miles to reset it.... it worked in my frontier ... I had the same problem as well
Hope that helped
Nissan tech +6 years
SOURCE: engine repair code P0325
I had a P0325 error code. Had my spare tire on the truck (2001 Nissan), which is NOT aluminum like the rest of the rims. I also needed an alignment BAD. Got 4-new tires and an alignment - problem SOLVED! I think the combination of a spare tire and an out-of-aligned problem through the knock sensor off. RUNS BEAUTY! I was also told, you NEVER need to replace a knock sensor...by the dealership.
SOURCE: Timing belt change for a Nissan Frontier
how to replace the timing belt on my 2000 frontier 2.4
SOURCE: change brake light bulb on a 2000 Nissan Frontier
The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.
213 views
Usually answered in minutes!
Is there any parts I should replace for sure or is it meant for a mechanic?
×