2007 Cadillac CTS 3.6L Logo
jon stump Posted on May 25, 2012

P0017 code on 2007 cadillac cts

Sluggish acceleration, check engine light on with p0017 code

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Greenhorn:

A rookie expert who has answered 20 questions on their first day.

  • Contributor 32 Answers
  • Posted on May 25, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Greenhorn:

A rookie expert who has answered 20 questions on their first day.

Joined: May 25, 2012
Answers
32
Questions
2
Helped
10516
Points
88

Cam crankshaft position sensor b bank 1

5 Related Answers

Anonymous

  • 2004 Answers
  • Posted on Jul 15, 2009

SOURCE: check engine light comes on and car starts to downshift hard

Please take the car for a scan to reveal any problem/ error codes causing this.

Good luck,

Ad

Mike

  • 4383 Answers
  • Posted on Sep 16, 2010

SOURCE: 2007 Cadillac SRX check engine light on steady

Something is wrong, pull the error codes and proceed on that indication.

Anonymous

  • 3 Answers
  • Posted on Oct 12, 2009

SOURCE: 2007 cadillac cts 3.6 motor...engine stalls.

CTS are very sensitive to problems with the hose between the air filter box and the intake. If it is not on good or leaks, it will cause the car to run rough, or die immediately after starting.

Anonymous

  • 1010 Answers
  • Posted on Jul 02, 2008

SOURCE: CTS CODE PO420

most of the time its the sensor that cause this,id try replacing the sensor on it,that usually fixes that code,but you have to get the code cleared off with a scanner ,and then re-scan it to make sure it doesn't come up again,good luck with it.

Anonymous

  • 6784 Answers
  • Posted on Mar 26, 2009

SOURCE: CTS check engine light code P0451

Hi. the fuel pressure sensor is part of the fuel pump assembly. You will have to remove the fuel pump to replace this. I would go ahead and replace the fuel pump while you are there.You will have to Pull the strainer off the fuel pump and discard it. remove the retaining clip for the fuel pressure regulator so that you can remove the fuel pressure regulator. Disconnect the electrical connections for the fuel pumps and the fuel level sensor. Remove the retaining clip for the fuel level sensor and remove the fuel level sensor by squeezing the locking tangs. the sensor is incorporated in this area.

Please rate and god bless.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2helpful
1answer
0helpful
1answer

06 cts 2.8 sluggish acceleration but after being cut off for a few hours runs good throwing7 codes

Post next that you did change the fuel filter and the fuel pump. The computer won't get the fuel issue.
1helpful
1answer

2004 Cadillac CTS check engine light on for about 5 days and car jerks when trying to accelerate

the first thing you need to do is get the vehicle scan as the check engine light is up meaning you vehicle is in limp mode
1helpful
2answers

Cadillic 2003 cts won't start

Temperature sending unit could be sending erratic signal.
0helpful
2answers

2007 cadillac cts engine cylinder misfire

Error code p0300 indicates rough idle and p0305 indicates engine misfire in cylinder 5. Check for faulty spark plug and its wiring. Also check for ignition coil and distributor. Replacing spark plug and its wiring may resolve the issue.
0helpful
1answer

Rides sluggish has about 72k miles on it check engine light came on then went back off

The check engine light will store a code that is causing the problem. Here is a link to help.
http://www.fixya.com/cars/r6017267-check_engine_light
0helpful
1answer

My 2007 cadillac cts engin service light is on. I used OBD-2 code reader to read it, got a alarm code P0496. What's the meaning of P0496?thanks.

Check the gas cap,also,it could mean the evap system is not working,or you have run out of gas recently,if all this checks out ok,then the tank is not venting properly.
0helpful
1answer

I was told that if I push F1 and F6 at the same time on my Cadillac CTS the service code will show up so I can find out why my engine light is on I have a Cadillac CTS 2007 I tried this but there was no...

the easiest thing to do is take it to an auto parts store and use their scanner on it. I think maybe you need to have the ignition switch turned to accessories when you push F1 and F6. Hope this helps tim
16helpful
4answers

Reset oil life display after oil change?

THIS SHOULD BE IT.
How do I reset the Engine Oil life monitor and how does it work? TO reset To reset the Engine Oil Life monitor do the following:
Reset Oil life in NAV/DIC by (with car running) going to INFO>Oil Life>RESET
Press and HOLD until XXX turns to 100%
How does it work? The oil life monitor is a pretty sophisticated algorithm.

GM "The GM Oil Life System will automatically adjust the oil change interval based on engine characteristics, driving habits and the climate in which the vehicle is operated."
Not finding what you are looking for?

2,718 views

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...