Runs rough, shifts poorly, idles rough but doesnt stall...OBD II check found several trouble codes, including Ignition coil a primary circuit malfunction, misfire cylinder 1 at startup, lean system on bank 1. Already changed ignition coil on cylinder 1, didnt change plug though.
From Lusty Kid:
I know the economy is bad, but change all of the plugs. Check your PCV Valve hose, 150 rottens them out allowing air to be sucked in, thus all kinds of codes.
Depending on mileage. Dismount the EGR valve and clean passages. If you are really good dismount the throtle position sensor body and clean out passages with Choke Cleaner., dismount where the EGR valves connects to the engine, clean out passages. Also check the hose thats behind this mounting to ensure is not clogged. If clogged clean it out. If not replace it. Is about 1.5 ft. long, connects to the PCV Valve Hose.
When is the last time you change your harness. Can't remember??? Replace it. Good Luck
1,501 views
Usually answered in minutes!
I have code problems with my 150 code po172,po300,po304
runs good at startup . runs bad after about 30 sec or so
Truck idles ruff after it gets driven for a while then wants to stall when stopping at light
engine misfire on cylinder number 4
Hooked up to computer at auto parts store and read 92 sensor for #1 cylinder bad. Changed it and engine still shakes while idling and while driving. Engine seems to run fine though, did not change plugs yet. Thought they burn out when sensor was bad. Anyone have this problem that has answer to a fix? This on a 96 FORD EXPLORER XLT 4.OL engine.
lean bank 1
car idle rough and misfiring when driving,have tested coils with timing light and ok,replaced spark plugs,no change..ran some injector cleaner through and has improved a little but prob is still there,powertrain check is on ,any advice would be appreciated.
motor runs rough is there any other parts of the ignition system i should check or parts to replsce
stalls after warmed up, rough idle, engine code lean on left bank
×