Just driving alone everything was prefect the abs light came on them the trac control light show off ( and would not turn back on with switch) the check engine light started flashing on and off. then it died and red lights and would barley start back the codes that come up were 168.4, 13.5, 44.2, 455.4 and the brake petal got really hard like power brakes failed or somthing. any ideas?
All the problem you are facing will be solved easily by your own with the help of service and repair manual with diagram it will save your money also and you can get the manual from the given link http://toolsnyou.com/
SOURCE: brake and abs lights and engine light on
have to pull the codes on each system to find problem but the other shop should look at it again if they just worked on it
SOURCE: brake pedal being soft on 02 town and country
Add brake fluid and bleed the air out of the brake lines.
SOURCE: ABS light and trac control light off
YOU NEED TO HAVE ABS CONTROLLER SCANNED FOR DIAGNOSTIC TROUBLE CODES..THE SYSTEM HAS DETECTED A FAULT..A GOOD SCAN WILL YOU LEAD DOWN THE PATH TO FIXING THE PROBLEM..YOU CAN SEE IF WHEEL SPEED SENSORS ARE NOT WORKING,IF YOU CAN'T COMMUNICATE WITH CONTROLLER,ETC..LET ME KNOW WHAT IS FOUND
SOURCE: I have a 2000 Chrysler 300m and when I start my
sounds like your abs trac control module is going its located on the front drivers side behind wheel well cover , 850 for new best to pick up from junk yard about 100. module changed in 2002 . make sure you get right year .mine went lost all break fluid no warning canister rusted out.
SOURCE: I got the ABS Light on my 2005 Chrysler Town and
Stop at a Tuffy or other shop and they can scan for codes to tell you which sensor may be faulty. Wheel sensors are easy to replace.
285 views
Usually answered in minutes!
×