It may or may not be the starter itself, find out if there is anything else that runs off that fuse and track down all ground wires associated. if all the grounds are connected, you've got a bare or broken wire. probly best to take to a reputable auto electric shop.
SOURCE: oil sending unit on 2004 chrysler sebring V6
Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove
SOURCE: replace air filter 2002 Chrysler Sebring convertible
you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.
SOURCE: Airbag light stays on in 2004 Chrysler Sebring
Sounds like you need to get it scanned for trouble codes. It will most likely need a new air bag clock spring. This is the wound connection under the steering wheel, it is a common failure item. It may be some other things related to the safty restraint system, but that will show up in a vehicle scan.
SOURCE: 2004 chrysler sebring idle speed is too slow. HOw
why do you want your rpms higher while idling? you don't want them high because your gas bill will reflect that. slow shouldn't matter but if it's dying while on idle it could either be your mass air flow sensor or your fuel filter being clogged
SOURCE: Where is the fuel filter located on a 2004 Chrysler Sebring Sedan
Some of the Sebrings have two filters(one is called a sock).The sock(which all sebrings have) is located in the fuel tank itself on the pump module.If this model is the JXI then the external filter is located on the belly of the car between the tank and drivers rear seat. I hope I could help!!!
610 views
Usually answered in minutes!
×