Help putting on 2008 exterior mirror

Aqu? tienes el diagrama de encendido para un Chevy Impala LS del a?o 2008 con motor de 3.5 litros:

Frente del veh?culo
?
2 4 6 1 3 5
? ? ? ? ? ?
? ? ? ? ? ?
BOBINA 2 BOBINA 3
? ?
? ?
BUJ?A 2 BUJ?A 3
? ?
? ?
BOBINA 1 BOBINA 4
? ?
? ?
BUJ?A 1 BUJ?A 4
? ?
? ?
BOBINA 6 BOBINA 5
? ?
? ?
BUJ?A 6 BUJ?A 5
Recuerda que este diagrama representa la secuencia de encendido de las bobinas y buj?as en un motor de 6 cilindros. Aseg?rate de seguir las recomendaciones del fabricante en cuanto a las especificaciones de las buj?as y los intervalos de mantenimiento para garantizar un funcionamiento ?ptimo de tu Chevy Impala LS 2008.

Allen wrenches usually come in a set, try 3/8.

Do you mean what causes low oil pressure? This is a very reliable engine for the most part. If the oil light is on or gauge is reading low, have the oil pressure sensor inspected for failure. These sensors do go bad.

Put in your search engine , Recalls on a 2002 Chevy Impala LS it will bring up quite a few good sites to pick from. They were more recalls then I could put down here.

could be a wheel bearing going dry

I used google to do a search for this and typed in "instructions replace side mirror". There is a guide on e-bay that pops right up and it gives you pretty detailed instructions. They are not vehicle specific but should give you all the information that you need. The web page says How to replace a broken side mirror on your car-associated content. I hope this helps, it looked like it had plenty of great information.

The oil filter on the 2008 Chevy Impala 3.5 V6 is located to the front center of the engine and recessed underneath and slightly to the right (passenger) side just behind the front frame crossmember.

PLEASE RATE THIS INFO

I'm going to assume the 2008 is similar to my 2006. The mirror is attached to the door with (3) 10mm nuts behind the triangle shaped interior trim piece that pops off easily with a screwdriver. If you have electric mirrors, the door panel has to come off to unplug the wiring harness from the mirror. There are three T30 torx screws and a 7mm bolt that need to be removed first...two torx bolts are under the rubber pad in the door grab well and the other is under the plastic trim piece behind the interior door handle. The 7 mm screw is behind the door reflector. Once the torx bolts and 7mm bolt is removed, pry the door panel at the bottom (there is a slot for this) and release the plastic connectors around the panel's edge...some effort is required to release them.

If you need to replace the entire mirror - it's a little involved. First you need to take the upper extension panel off from behind the mirror (black triangle) - just pull it of starting at the top. It will snap back on later. Next - remove the different screws holding the door panel in place (not the ones behind the mirror yet!) One is under the handle (pull it out and pull out the filler panel - small plastic thing that has a hole to pry it out). Then take off the rear red light - also pops off - and remove that screw. Finally - pick up the rubber filler where your fingers pull the door shut and remove these torx bolts.

Now is the tricky part. Snapp off the entire interior panel. It will pop off - but very difficult. It will sound like it is breaking! Start at the outer bottom corner - and use a door panel remover tool - check Amazon or E-bay - to keep from breaking things. Pull it out from all around the bottom and sides and then lift it up over the door lock. It good to have a friend help here. The panel will still be held on by a cable - that is your door release - leave it alone and let the panel hang by it (or better, put a box under it to rest on).

Now...remove the three bolts holding the mirror on - have a friend help hold the mirror while you do this or it will scratch your new car! Since the inner panel is off - you can also disonnect the mirror plus and remove it. It sounds silly - but the only reason to remove the door panel is to unplug it!

Get you new mirror and reverse the steps.

If you are just replacing the glass (non-heated) - get a replacement from the dealer. Adjust the mirror all the way to the inside and reach behind and pop it off. CAREFUL - put tape over the entire glass as it will likely break even more! Remove your connectors if heated - and replace (and reconnect) with your new glass. It just pops back on!

Replacing glass is easy - just be careful of cheap imitations on e-abay). And never use cheap flat glass on the passenger side! The DOT has special requirements for mirror glass - buy it from gmpartsdirect.com or your local dealer.

kb

I did a complet brake job on my 2004 Chevrolet Impala about two weeks ago, and i still have warning light on. Thw system is working great. So how do I turn off the warning Lights, Traction off light, Brake light, and in warning center Low brake fuild?