Have notived recently that the wiper blades in my audi a4 2006 judder when I sue them. Even with a lot of water on windscreen that judder. I have checked the wiper blades for any damage but they are both in good condition. I have also cleaned the windscreen to make sure there is not dirt or similar on it. Judder problem still there. Any ideas???.
Lift the blades away from the screen enough to use a cleaning wipe along the edge of each rubber or a cloth with vinegar and water mixed. Should do it unless they have really reached the end of life, Not too expensive to replace.
Yeah Brother, makes no diff what make the vehicle is, when the knuckle on the wiper arm is warn, and they all do, it will make the wiper blades jump like that when in use. You're only recourse is to buy new wiper arms for your toy. They won't do that any more, or till the new ones are warn.
SOURCE: audi a4 wipers havejust stopped working
I have the same problem. Check this out.
http://www.audiworld.com/tech/misc44.shtml
I am working o it
SOURCE: Audi A4, ESP light, engine judder
could be a bent valve but all depends how much da car means to you if you want to keep your car bring to a local garage or specialest ask them or bring it to a place where dat modify cars and ask them how much dont always go on 1 garage quote shop around and pull a fella in a garage to the side and ask em would he do u a favour as an nixer to do the job and see want he says come bak to me if notin happens
SOURCE: how to remove audi a6 wiper blades
The problem with this wiper blade set up is the slides get jammed up w/ crude. You should lubricate the slides and they should slide off. Then carfully lift the arm and remove the blade. Warning you should never leave the arm in the upright position. Windshields get cracked this way. Also note the pivit points the blades attach too. These will normally sieze up and cause clearing issues even with new blades. Lubricate these pivit points and use a pair of channel locks to move it back and forth until it will go 360 degrees with your fingers. Install is in reverse order of removal.
SOURCE: brake pedal judder when bkaking
It sounds like the front calipers,did you change the front brakes also? when they wear down past piston tollerance,you will get the push back on your brake pedal,also flush out all the used brake fluid,and replace it with fresh.When you have the calipers off,lube the pistons with bearing grease,you can push the pistons down with a c-clamp.It sounds like the whining noise is from low power steering fluid,to know for sure I need to know more details,from the noise location.
SOURCE: Slow wipers
i wouldnt bother checking for a feed as, it works it must be getting a feed, the most common fault is the spindle ( the bit the wiper arm bolts to) seizes up, i have repaired one of these, just remove the wiper linkage, remove the small snap ring and washer followed by a rubber sealing ring. i used a vice to push the spindle from the linkage, clean it up and regrease it with lots of bearing grease refit and jobs a gooden
98 views
Usually answered in minutes!
×