Where is the crankshaft position sensor located on the 1996 eclipse 2 liter non turbo?
Under hood, center, upper engine area, mounted on upper driver side of engine.
There are 3 possible engine options for the '96, u said it's not the turbo (F 2.0L MFI Turbo DOHC), that leaves the G 2.4L MFI SOHC or the Y 2.0L MFI DOHC, I'm interested in which engine you have. The 2 possible engines have different locations of the crank pos sensor. My info came from a auto parts website. I would also like to ask that u consider changing the rating to a 'thanks for trying' which I feel is more accurate than 'inappropriate.' Thanks for your time.
×
If u pull the battery and battery tray u can easily reach this
SOURCE: crankshaft position sensor location
Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.
1,770 views
Usually answered in minutes!
found it already.Its right above the oil filter in the engine block.
i need location of crankshaft sensor on a 2000 model vectra with a 2.2 motor
How to install position senor
need location of the crankshaft position s3nsor
Replacing crankshaft position sensor
×