1990 Lexus LS 400 Logo

Related Topics:

A
Anonymous Posted on May 10, 2012

1990 lexus ls400 is misfiring after using engine degreaser

5 Related Answers

mkv0525

Mike Vincent

  • 358 Answers
  • Posted on May 21, 2009

SOURCE: R & R 1991 Lexus Ls400 Gear shift knob

slide the lower part of shifter handle down and you will find two screws, but there is 2 wires coming in from center console for overdrive button.you have to remove the center console cover and remove the 2 wires from connector and then pull up threw handle.when you go back together you will have to guide them back threw the handle.

Ad

Anonymous

  • 11896 Answers
  • Posted on Aug 07, 2009

SOURCE: Replace/fix starter on 1991 Lexus LS400

Not too bad. Not much room, just enough to drop the starter. It is probably easier to go up through exhaust if you can get your exhaust shield off the manifold .

Patrick Rayome

  • 1757 Answers
  • Posted on Mar 11, 2010

SOURCE: need a wiring diagram for 1990 lexus LS400

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I have only been a free contributor to this site for the past 4-months.

I do not know if you still need this information, but I am going ahead and answering it anyway.


WIRING DIAGRAM:
For the 4.0L DOHC 8-Cylinder:
Cylinders:
(back of engine)
8.........7
6.........5
4.........3
2.........1
(front of engine)
Ignition Connections:
............(back)
|.o.o.o.o.o|..|.o.o.o.o.o|
|.^.^.^.^.^|..|.^.^.^.^.^|
|.2.8.C.3.5.|..|.4.6.C.7.1.|
.......O................O
.......I..................I
.......L.................L
............(front)

Again my apologies...
Let me know if this helped, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!

Anonymous

  • 15 Answers
  • Posted on May 18, 2010

SOURCE: how do i change my spark plugs on my lexus ls400

there located on top of engine under the cover thats says V8 FOUR CAM 32, 4 S.P. on each side,remove both covers and its easy access after that.

Anonymous

  • 1 Answer
  • Posted on Nov 30, 2010

SOURCE: how to repair code13 - RPM signal no.2 Lexus Ls400

HOW TO FIX CODE 13 1995 LEXUS SC400

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I broke a little plastic thing on the top of my engine on my 1990 lexus LS400 and I do not know what it is. I think it is some kind of sensor.

go to the auto parts store they can most likely tell you what it is and maybe change it for you tip them well
0helpful
1answer

How to remove headrest of a 1990 lexus LS400 power seats, can you help please!!!

On both sides of the headrest spokes are little adjuster rings. Adjust the headrest up to the highest position. Push down on both of the adjuster rings. While doing that, pull up on the headrest and it will pop right up. Here is a link to help you with all other questions: http://www.clublexus.com/forums/ls400/18383-trying-to-remove-front-seat-headrest-on-ls400-dont-want-to-break-it.html
0helpful
2answers

Can't find the latch to open the hood for a 1990 lexus ls400

Should be a release lever on the underside of the dash to the left of the steering wheel. It should be flush with the panel, so you might have to feel around for it. Hope that helps...!
2helpful
1answer

How do i locate the factory amp in a 1990 lexus ls400

in 1990 LS400, the amp is only for the sub, its located between the fuel tank and trunk liner. you can reach it by removing the trunk liner which cover the fuel tank right behind the rear seat. hope this helps
1helpful
1answer

I purchased a 1990 Lexus LS400.

well your best bet is take it to the lexus dealer to get your oil changed and just tell them you just got it and you would like it looked over good trust me as slow as shops are right now they are gonna do a good inspection hoping to make money.. lol but make sure you go to the dealer cause they know what the commen stuff ya know
2helpful
1answer
0helpful
1answer

1990 Lexus LS400

The starter is beneath the intake manifold on the top of the engine. Everything will have to be removed to get access to it . Once its uncovered, there are only 3 bolts on the starter.
Not finding what you are looking for?

41 views

Ask a Question

Usually answered in minutes!

Top Lexus Experts

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...