Cars & Trucks Logo

Related Topics:

Anonymous Posted on May 09, 2012

Fob stopped working for toyota previa and alarm keeps going off

I cannot get the fob to work when i change the battery on my toyota previa and now the alarm keeps going off. how do i disable it??

5 Related Answers

Don

  • 87 Answers
  • Posted on Dec 27, 2010

SOURCE: I have a 95 VW Jetta III that I just purchased.

Insert the key into the door lock on the driver side and move it to the unlock position two times quickly. That should turn off the alarm.

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Oct 16, 2008

SOURCE: key fob will not undo

If you don't have one that works for the vehicle now, you'll have to take it to your local dealer to have it programmed to the vehicle. Some will charge for this, some will do it at no charge.

If you do have a remote that is programmed and working for the vehicle, then the following steps will allow you to program another remote:

1. Enter vehicle and close all doors.

2. Put seatbelt on (or clip it into the buckle) to shut the warning buzzer off.

3. Put key in ignition, turn to run position but don't start it.

4. Press and hold the unlock button on the working key fob and hold for 4 seconds, then also press the panic button.

5. Release both buttons and you should hear a single chime to indicate it is in program mode. You have 30 seconds after the chime to program any additional remotes you want to program.

6. Press and release both the unlock and lock buttons simultaneously on the remote you are programming. You should hear another single chime.

7. Within 4 seconds after hearing the chime, press either lock or unlock button on remote that you are programming.

Anonymous

  • 20 Answers
  • Posted on Apr 25, 2009

SOURCE: alarm for audi A4

Try disarming the car from the trunk. Sounds like the door lock switch is not deactivating the alarm, which it should, with or without the remote.

Anonymous

  • 1 Answer
  • Posted on Jun 11, 2009

SOURCE: 2004 xtype jaguar key fob suddenly stopped working

Your key fob needs reprogramming, and yes the alarm will go off when you open the door, but you have enough time to put the key in the ignition which will prevent the alarm sounding. Car is usable until you get the fob sorted by locking and unlocking using the key.

Anonymous

  • 32 Answers
  • Posted on Jan 05, 2010

SOURCE: 97 toyota 4runner factory alarm not allowing to start

lock your doors and close it wait till alarm resets and then unlock door with key and this should take care of you problem

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Stock anti theft alarm stop working at the same time the locking door central stop working?

Check the body control module. All the items that you list can be controlled by that.
0helpful
1answer

Car alarm and the locking mechanism stop working

You may have to reprogram the keyless entry system hold the lock and unlock on the keychain you should hear the horn
0helpful
1answer

Deactivate alarm

change the battery in your fob. check the power in your battery may need a recharge.
0helpful
1answer

Key fob wont re set on my ssan yan rexton

I recently changed the battery on my key fob for my ssanyong rexton. I then did the following for the key fob to make it work. 1. Enter vehicle and close all doors.

2. Put seatbelt on (or clip it into the buckle) to shut the warning buzzer off.

3. Put key in ignition, turn to run position but don't start it.

4. Press and hold both buttons on key fob until red light on fob stays on. Then let go of both buttons. Then pressed the alarm button then the panic button, somthing like that. To be fair the button sequence after the red light came on is a bit vague. The alarm was blaring so i was happy when it just stopped.
0helpful
1answer

1994 toyota previa won't start. yesterday it would

If the eng. Is cranking over could be spark or fuel or antitheft is enabled is the antitheft light on or is there an aftermarket alarm antitheft device installed on vehicle?if you have a key fob try changing the battery in fob.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/craig_a14a43e01fd0835a

0helpful
1answer

My alarm remote wont work. We changed the batteries. What do we have to do now.

My 2002 hyundai santa fe 2.7 fob will not open the doors or activate the alarm on both fobs, it has just stopped working, I have changed the battery and the led light on the fob lights up when pressed. any ideas?
0helpful
1answer

Describe your 1992 Toyota Previa Problem: got in this morning put key in the ignition and nothing, like the battery was dead. Get out open the hood and the alarm starts going off. I bought the van used...

If its an after market alarm ,disconnect it from the van.You can buy a new different alarm later that will come with the control buttons and instructions.
0helpful
2answers
0helpful
1answer

Rav4 1999 t reg key fob not working

I know a website
that has every info on all vehicles and vehicle problems (common/basic and technical both), with their solution In detail.. it's www.reliable-store.com
Not finding what you are looking for?

497 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...