How can i remove timing belt on 2005 kia sedona

Removal & Installation

3.5L Engine

1. Before servicing the vehicle, refer to the precautions at the beginning of this section.
2. Record the radio anti theft code data.
3. Remove or disconnect the following:
   
   Negative battery cable Engine cover Accessory drive belts Idler pulley Crankshaft pulley Power steering pump pulley Belt tensioner pulley Upper and lower timing belt covers
   
4. Support the engine with a floor jack and remove the engine mount.
5. Rotate the engine to align the camshaft sprocket timing marks with the cylinder head cover timing marks.
   
   

   Fig. Timing belt routing and timing marks-3.5L Engine
   

6. Remove or disconnect the folhow can i remove timing belt on 2005 kia sedona - 0996b43f8022cb72.jpgbr> Auto tensioner Timing belt
   
   

   Fig. Timing belt and related components-3.5L Engine
   
   

1. Ensure that the engine is set to Top Dead Center (TDC).
2. Prepare the auto tensioner for installation by compressing it in a vise and installing a retaining pin.
3. Install the timing belt in the following order:
   1. Crankshaft sprocket
   2. Idler pulley
   3. Left bank exhaust camshaft sprocket
   4. Left bank intake camshaft sprocket
   5. Water pump pulley
   6. Right bank intake camshaft sprocket
   7. Right bank exhaust camshaft sprocket
   8. Tensioner pulley
   
   
4. Install the auto tensioner. Do not remove the retaining pin at this time.
5. Check that the crankshaft and camshaft timing marks are aligned correctly.
6. Rotate the crankshaft 1 / 4 turn Counterclockwise .
7. Rotate the crankshaft 1 / 4 turn Clockwise to return the engine to TDC.
how can i remove timing belt on 2005 kia sedona - 0996b43f8022cb73.jpgan>Loosen the tensioner pulley center bolt.
8. Apply 44 inch lbs. (5 Nm) torque to the tensioner pulley as shown and tighten the center bolt to 32-41 ft. lbs. (43-55 Nm).
   
   

   Fig. Adjusting the tensioner pulley-3.5L Engine
   

how can i remove timing belt on 2005 kia sedona - 0996b43f8022cb74.jpgRemove the auto tensioner retaining pin.
9. Rotate the crankshaft 2 revolutions Clockwise , then wait 5 minutes for the auto tensioner to adjust.
10. Measure the auto tensioner rod as shown. If the measurement is not 3.8-how can i remove timing belt on 2005 kia sedona - enlarge_icon.gifeat the belt tensioning phow can i remove timing belt on 2005 kia sedona - enlarge_tooltip.gifr>
    

    Fig. Measuring the auto tensioner rod-3.5L Engine
    

11. When the auto tensioner measurement is correct, install or connect the following:
    
    Engine mount Upper and lower timing belt covers Belt tensioner pulley Power steering pump pulley Crankshaft pulley Idler pulley Accessory drive belts Engine cover Negative battery cable
    
12. Reprogram the radio anti theft codes