2004 dodge intrepid w/a 2.7. Check engine light came on and the engine started shuttering a mile away from home. Limped her home, and figured it was the cam shaft position sensor. (Had same symptoms in the past with this car) replaced sensor and no luck. Still shutters, and has a real bad gassy odor from tail pipe. No way to scan the check engine light for a code...

SOURCE: crank shaft sesor/cam sensor problem?

If you had a fault with the crank sencer your car would not start.Sounds like the air flow meter is giving you the problems.

SOURCE: 2005 Dodge Stratus ? Camshaft Position Sensor causing problems (I

I had the same problem with my '05 Stratus SXT 2.4 DOHC. I've replaced the cam pos sensor and it seems to be running fine right now. On the Dodge forums a lot of the guys say that you need to replace the crank pos sensor too. I've bought one of those just in case it comes back again. Hope this helps.

SOURCE: 2000 Dodge Intrepid with PO455 code and stalling.

A code 455 most likely one or more of the following has happened
a loose or bad gas cap
a non-conforming gas cap
other leaks or damage pieces in the evap system

Inspect the evap system for cracks or breaks in lines listen for vacume leaks or strong gas fume smell and fix all lines you find that are damaged ..I know you say you put a new gas cap but make sure it a conforming cap..Hope this helps

Testimonial: "Thank you!! I will def. tell my husband to check it out!! Thats the only code that comes up. So I hope this will help."

SOURCE: I have a 2004 Intrepid and the check engine light

I had a Kia that had the exact same problem. it was because the new fuel tank cap didn't seal correctly even though it seemed to fit fine.

SOURCE: 2001 dodge intrepid,going down road gauges went

did the battery cable come off or is it real lose?