Remove front bumper 2011 bmw x3

SOURCE: bmw bumpers .. quick

Hi i have just put the rear bar anf front bar form a e36 convert on my saloon that i got from the scrap yard the other week and they fit fine for me..... i hope this helps you.

SOURCE: How to install front bumper cover on 2001 BMW E39

Installation of the Molding
Take the Molding Trim whether it is stock black or painted. Mine is black because my car is a year 2000. Painted side moldings were done in the year 2001. Snap them into place.
5 Installation of the Rubber Gaskets
From the stock bumper, retrieve the upper rubber gaskets unless you ordered new ones. Simply take a screw driver and pry a corner off to get you started. Wash thoroughly. NOTE which one belongs on which side.
Place the rubber gasket on the M5 Front Bumper onto its appropriate side. Top The M5 Bumper is now Fully Assembled!!! Place aside where it can't be damaged.

SOURCE: how to remove frt bumper on 325 bmw

remove 8mm screws at r and l side splash sheils, remove t 50 torx bolts under bumper cover on either sdie of where the front lic plate cover goes, pull away from body of vehcile and disconnect the fog lights if equipped

SOURCE: how can i remove door handle of bmw X-3

If you have the door panel off already. you have to look at the back of the door latch mechanism. you will see where the wire for the door handle hooks to the door. If you are starting you have to be very careful in removing the screws for the door panel look for the hidden screws under caps with cutout.there should be a toric screw where the door handle is and another one close to where the mirror mounts. again look for caps