Rear seat
SOURCE: rear wheel bearing
SECTION 205-02B: Rear Drive Axle/Differential — Ford 8.8-Inch Ring Gear
2003 Mustang Workshop Manual
IN-VEHICLE REPAIR
Axle Shaft
Removal
Remove the U-washer (4N237).
Carefully remove the rear brake anti-lock sensor. For additional information, refer to Section 206-09A .
--------------------------------------------------------------------------------------
Remove the axle shaft.
Rear Wheel Bearing and Axle Shaft Oil Seal
Removal
Installation
Using the special tools, remove the rear wheel bearing and wheel bearing oil seal.
-------------------------------------------------------------------
Installation
Install the two axle shafts.
Install the U-washer.
Install the differential pinion shaft.
SOURCE: rear main seal is leaking on a Ford Mustang 2003 V-6
In order to replace the rear main seal u have to pull the transmission out to access it, u will need a special seal installer tool to install the new rear main "full circle seal", it u don't use the special ford tool the seal will leak again, also if there is a groove worn ion the crankshaft the crank must be repaired or replaced or the or the seal will leak again, so this is avery diff job, a 9 on the scale of 1-10 with 10 being the mos difficult.
SOURCE: A diagram of a 2003 Ford Mustang interior fuse box?
here you go
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp
SOURCE: refill gear oil in rear differential on 2003 ford mustang gt
The differential will have a plug in the driver's side of the housing that is removed with a 3/8" drive ratchet or square drive. Be sure you know what type of fluid is recommended for your vehicle. It will depend on whether it is a locking differential or standard.
SOURCE: how to remove rear seat back 1987 mustang
Tools Required:
-------------------
Installation:
Remove Back Seat:
for more help click this link directly
111 views
Usually answered in minutes!
×