1999 Honda Accord steering problem

accord stalling on every stop. (1/2) - EricTheCarGuy ...

www.ericthecarguy.com/.../8.../46884-accord-stalling-on-every-stop

The car runs good but stalls every time i come to a stop. ... a stop then it diesagain.only on the stops does the idle drop very low to the point of stalling.what ... only when I start slowing down and come to a complete stop RPM's go down and the cardies. ... The popular Honda Civic and Accord vehicles share many powertrain ...

1998 Honda Accord loses rpm/ stalls coming to a stop ...

honda-tech.com/honda-accord.../1998-honda-accord-loses-rpm-stalls-co...

Jan 10, 2013 - I just bought a 1998 4 cyl 2.3 L Honda Accord two days ago. ... 1998Honda Accord loses rpm/ stalls coming to a stop. .... Is clockwise high idle or low idle? all in all i probable rotated counterclockwide 1.5 or 2 turns. maybe this ...

1999 Accord, 130k+, stalls when slowing to a stop - Honda Accord ...

www.hondaaccordforum.com > ... > General > General Tech Help

Mar 10, 2010 - My fiancee's '99 Accord EX Coupe 4-cylinder automatic, with 130,000+ miles, has recently (in .... No low RPM & feeling like it's GOING TO stall.

99 Honda Accord - Strange Stalling Issues! HELP!

https://www.2carpros.com/.../1999-honda-accord-99-strange-stalling-issu...

My 1999 Honda Accord is having sporadic stalling problems. I've noticed a pattern. Itstalls while going slow speeds and stop and go traffic, etc. The engine just ...

Stalling or Low Engine Idle Speed Due to Dirty ... - Repair

Hi,
Look in the Owner's Manual on how to check the Power Steering fluid. Also the belt may need adjusted or replaced.
GL,
TD

fast or gradually in 10 years.?????
1: engine stalled?, normal..
2: engine at 800 rpm or more, not normal ?,belt fell of pump.

The steering is controlled by the steering rack,
& they get stiff because no one changes the fluid
every 3 years

The upper strut bearings fail & make steering stiff

Doubt the pump was a problem at all

Bearings on top of struts

Make sure that you have the correct
Honda only fluid, in the steering system

If not, flush it out

this problem is caused by a failed rack and pinion steering gear failing

the lever is greased from the factory and at 60k km that grease may be displaced. if you are handy enough to remove the center console around the shift lever, you can re-grease it yourself. also where the cabling connects to the transmission may be in need of adjustment if the aforementioned solution does not correct it. also be sure and service your transmission (fluid/filter changes)

the trans will actually bolt up to the engine..but it will not work properly without the pressure switch plugged in to the harness... if u notice, there is a hole with no threads in the prelude trans..u couldnt even thread a 3rd gear pressure switch in the trans case..trust me ive seen it b4 at the dealer where i work.. i even went as far as installing the trans and when going back together, saw the difference when trying to plug the harness in...its not the same..i laugh about it now, but was very mad at myself at the time for assumeing the parts guy brought me the right part..the guy with the prelude was about to install my accord  trans in his prelude ...luckily i was able to stop him b4 he installed my trans in his prelude...i laugh about it now

sounds like your shift cable is starting to seize to the casing around it..

Automatic or manual? May be low transmission fluid, or (less likely) bad CV joint. Have mechanic get it up on the lift and check for leaks, then spin the tires, see if the noise will manifest itself.