Interior light bulb on vw bora - 2000 Volkswagen Bora

SOURCE: interior light bulb on vw beetle

I had the same problem. Found the solution online - The Golf Mk IV has the same fittings. Pictures here: http://uk-mkivs.net/forums/t/255147.aspx

SOURCE: where is the diagnostic located in the vw bora 16

Depending on the year of the car.....Usually the diagnostic plug is fitted in the centre consol.. A small plastic strip must be removed.....in front of the gear shift...below the radio.
Sorry I can not help with tranmission
John

SOURCE: VW Bora: Can't open bonnet

first of all not an easy job,you need to get the front grill off and look upwards for a cover that will be covering up the bonnet catch,basicly bend or pull this off,you should then see were the cable goes in,then you should be able to bar the catch with a screwdriver to release it. best of luck

SOURCE: wiring for a towbar on a, vw bora

The following is the wiring for your towbar
Check the inside of the socket and you will find each of the 7 pins are numbered 1 - 7.
No 1 Yellow Wire. Left side Flasher
No 2 Blue Wire. Fog Light.
No 3 White Wire.. Earth.
No 4 Green Wire. Right side Flasher
No 5 Brown Wire. Left side Park Light.
No 6 Red Wire. Brake Lights.
No 7 Centre Pin. Black Wire. Right Side Parh Light.
Hope This helps.
John

SOURCE: My interior lights won't turn on when I open door on vw bora

There's a switch that's usually located around the door hinges; you should be able to see it if the door is open. Sounds like the switch is bad, and isn't completing the circuit when you open the one door. Open the door, and see if you can wiggle the switch. If so, see if it will turn the lights on. It won't always do it, but if it does, it will confirm that it is sticking. If not, you may have to take the switch out, and jump the two leads to see if the lights will come on. If they do, go ahead and replace the switch. If not, test the two wires with a multimeter, looking for around 12-16 volts DC. If you have power there, then the switch is bad. If you do not, then you need to trace the wires and find the break in the wires.