I recently replaced my 2002 pontiac sunfire's battery, and after turning the car back on my fuel gauge thermometer speedometer and tachometer no longer read. the lights in the instrument panel still work however (turn signals, check engine and so on). the car still works but i am uncomfortable driving without a speedometer at least as the cops in my town are quite strict. A friend has suggested that it might be a blown fuse, but i am unsure.
Just pull out the 10amp cluster fuse and put it back in. The cluster will pop right back up. My 2004 does it every time the battery goes dead.
Yep
Was this for me
...
I deconect my batteries cause need to fix my Power strearing hose and remove m'y computer and when i put everything on place m'y cash was crazy ... Full Light ... No Light ... No Meter
....
i remove that fuse you Say and YESSSS
it work m'y problem is fix ...
Was scared to remplace m'y computer
XD thanks
Silly question here is the car running when you pull out and put in the fuse?
I had to do it a few times and sometimes all the warning lights would stay on even when you shut the car off. I did it with the car running and with it off
×
It's your fuseable
link .
There’s a ground bolt that connects the (-) in the front of the plate where the battery sits. It must be connected. It’s a frame ground. I tried to mount a top mount battery and that cable wouldn’t reach. Instrument cluster gauges were all erratic. Got the right side mount battery, connected that ground and all gauges were back to normal.
SOURCE: Speedometer/ Fuel Gauge & Tachometer not working
check for loose connection at the instrument cluster.
SOURCE: 04 pontiac sunfire battery light and panel lights dim
sounds like your alternator. if you have a multimeter then turn on your car and turn your headlights on/ac and heater fan on high/wipers on and blinkers on. once they are all on hook the meter to the battery and if it reads less then 14 volts then the alt is bad. or you can just take it to a shop and have it tested.
SOURCE: MY TURN SIGNAL QUIT WORKING IS THERE A FLASHER
My service manual states that the '02 T+C has a combination turn signal/hazard flasher/daytime running lights module which is located on the junction block, adjacent to and left of the steering column. To access it, you must remove the steering column lower cover and knee pad panel. There is also a fuse for turn signal/hazard flasher. If none of them work, check the fuse 1st.
SOURCE: Everything works fine on my vehicle EXCEPT today
Check the fuse for those items that don't work.
5,330 views
Usually answered in minutes!
×